Recent content by Hinkman

I did have to clean the connector down at the solenoid since it was intermittently engaging when I serviced it. After a day of riding it started making a weird howling noise like a dried out bearing. I never thought to spray connections with WD, that is a great idea!! I am definitely going...

My 06 Apex GT is making some noise while starting, sounds like it has a bad bearing or something and the engine spins slower than usual. Can someone recommend a vendor who can get me one this week at a fair price?

Looks I need to replace mine, it is making an odd noise when I start it. Who can I contact to get me an OEM one in the next week?

My sled did the same thing with cr10ek plugs. Once I took them out it went away.

Iceman, You are correct, but if you don't try, you'll never know.

How about creating an OPEN or SHORT CIRCUIT in the Coolant Temp Sensor wiring???? When the ECU sees this condition then uses a default value of 140 degrees F instead of the actual 195. That will richen the mixture and give you hp..........................However I will save you the...

It is just a coil of wire in a plastic looking donut with a pig tail on it. You can't get it out without breaking the head off where the wire used to come out. Once you break the head off, there is an O-Ring type clip you need to remove to pull the rest of it out. Dealer pricing is about...

Thinking about heading up Friday...........how are the trails up there??? The trail report for the Houlton/Linneus area haven't updated their status since December 17th on the SledMaine site.

When you hold the throttle WO during start up, in most fuel injected vehicles, it puts the Fuel Injection system in CLEAR FLOOD and the ECU will not fire the injector/s. This allows you to clear the extra fuel out of the cylinder and HOPEFULLY if is't not flooded too bad it will start. You may...

RTX Rox, This was copied from www.ulmerracing.com, INSTRUCTIONS, STEALTH AIR BOX (Moderators, delete it if unappropriate) Ulmer Racing 43230 290th St, Menno SD 57045 Phone: 605-387-2833 Fax: 605-387-2883 Email: Srxspec@Gwtc.net www.ulmerracing.com Stealth MOD Air Box...

1xr, I like that idea, what did you use for the rubber insert?? It looks familiar... I did some testing behind the house. Throttle response after the mod was a little sluggish and it had a numb spot off idle when I blipped the throttle. I had to set my CO values to +13 to get rid of the...

Hiperfax with wearpads in the closed windows........... What are these things, can you point me to a link that shows a picture of them.

ROCKERDAN, MUSKOKA APEX RTX 07 This is prolly a dumb question, but do you guys run wide open for miles???......I'm concerned about leaning it out on a long run.

Thanks ROCKERDAN, I have read your thread, but never been able to see the pictures, so I wasn't sure what you did. Now I can see them for some reason, nice job BTW. You're pulling in cold air and are at +15 on the CO's..........seems like if anyone was going to run lean, it would be you...

49 reviews and only 1 response..................maybe more people have the same question. ROCKRTX, I just set it to 20 as a precaution. It does seem rich on idle and idle rpm is down a bit. Maybe I should drop it down. Have you run it flat out for a few miles and looked at the plugs?