Search results

I have been riding my crossfire and nytro without a windshield since we got them and ride in Maine. Only problem I have had with windchill is when i do not ride with my face mask. and even those problems don't happen till i am constantly going high speed, which by what you said doesnt seem to be...

The base model ACE 900 mxz is more expensive than a base model nytro(10500 compared to 10000)...Will probably weigh the same as well, but has 45 less horsepower. Yamaha sells more highpower sleds than they do lower powered ones. Which is a reason to not offer or spend too much development of a...

Post some pictures!

If your only running studs for a safety reason i think two per row would be enough.

Too bad the snow in this area has been washed away by the warm weather and the rain...

Go beyond a visual inspection and check for continuity through the grip warmers. If you find nothing there the next step for me would be a check for voltage drop between the power source and the warmers and then between the warmers and ground.

Part number is on their website and a picture of what is in the mounting kit is here: https://www.denniskirk.com/mounting-sho ... 106101.prd for some reason denniskirk stopped selling them, but they are still available.

They now list a specific kit for the phazer/nytro. it includes rubbers, bushings, and spacers for the mounting as well. I believe it is part number 35-383 and the pictures i have seen show the above.

For those interested in running powder pro skis on their nytro or phazer, i recently found out that SLP now offers a mount for them. Ordered ours yesterday and they should be in by the end of the week!

What will you be using for an intake? It would be cool to make in in similar design to the new cats where the intake comes from around the gauge. That way when in deep powder the intake will easily be able to get air.

I live close to you and if i ever see you on the trails don't be surprised if i wave you down! haha. nice tunnel can't wait for more pictures!

Keep the rails and change other colors, a green nytro would look very original!

I like the fact that the sled sits in the actual bed rather than on top like the sled decks. Even a single sled sled deck is a grand also. Looks like it is also easily removable, and can be used for an easier way to load an atv and not have to worry about setting up ramps.

Wow.

There is a yamaha on here somewhere with something like 50000km show him that they can last that long with no engine work.

The site is working for me. In case you still can't get it to work the skid price goes from 1500 for base shocks and up to around 2000 for fox shocks. As well as an additional 500 for iceage rails. these are just rough numbers from their website as it would take very long to give all the info!

Looking to possibly install some extra idlers on my nytro since installing the 144 extension. I am looking to use the stock mounting brackets that i believe are used on the stock idlers. Was just wondering if anyone has any ideas on installing them on the inside vs the outside of the rails. they...

There should be markings on the bearings themselves marking the size and model. Any place that sells bearings may have them and just in case bring you old ones to match up. I am pretty sure they are just a generic size and nothing that is special to yamaha.

I think using the measurements of mountain points on an xp sled would be better than using the measurements of the skid with no weight on it. If you have ever installed your nytro skid the torsion springs need to be disconnected to line up with the holes, I can imagine it would be the same on...

No problem. I took photos of the specifics of those as in the pictures on here I could not tell either.