Search results

Just went to their web site, yes they do.

Snowtrackers!!!!!!!

Found a better one in FAQ.

So I got a manual for the MrSled and the wiring diagram is of such poor quality that it is useless. would any one know where I can get a decent copy. Thanks.

Just use marine grease in the bearing, it's lithium base (wax) which doesn't wash out like oil based grease. I re-grease mine every year and am still running all the same bearings that I put in to replace the wheels with the non-replaceable bearings.

Just make sure you use plated steel. The aluminum ones won't last.

The bearing nut part 19 screws onto collar 18 to align the bearing on the shaft. The shaft comes out from the clutch side and unfortunately you have to disassemble the chain case. I had to set one up once before but do not remember the procedure to set it up. when you screw the two parts...

Do you mean the bearing nut that is part of the secondary clutch?

You might have noticed my posts earlier in this thread so I did a valve adjustment to my sled and seems to have cured the idle/stall issues. Some of the valves were at .002" which is way below the proper setting making me think they were held slightly open when the engine was warm. Just my...

Approx 14" if I understand your explanation. I measured from the windshield along the support 2" and then across.

There is only 1 red/green wire , the red/blue has a green band going around it but is not a colour indicator. Steiner, no oops in your write up.

Check where the hood locks are at the back, That's what lines up the hood.

Glad you got it fixed.

My tank was cracked on the back side of the bottom front flange. Remove the tank and inspect.

I don't know, the one I saw was at a stealership and seemed to be holding fine.

I'm not sure of the specs of that spring.

I've seen that style of lift used with wheelbarrow tire out in the yard that worked good and the sled can be left on with out flattening the tires.

By looking at the yamaha spring spec's the ypy should give a slightly lower engagement, also will affect shift rpm slighty Spring pre-load affect engagement speed and total force affects shift rpm. Spring specs Pre-load/Spring Rate/Total Force/Free Length/Wire Dia Stock YSY 35...

I hear ya!

Boy those plugs are pretty black. My Attak are always tan coloured.