Search results

I have a 2012se with 7,000 miles on it. I'm getting a code 43 and now a new 13. I definitely missed or can't find the problem. What I've done so far. Checked grounds. Eliminated grounding blocks. Replaced stator. Installed new ECM and also tried one from a running sled without codes Cleaned...

I was told long time ago never to run engine and rev it without a belt on it. Ive herd of people doing this and would like others ideas about that. I'm sure the list of why not to do this is longer than the list of to do this.

I'd like to have a turbo added to my sled. I live in upper Michigan. I'm looking for someone who has experience in installs. I'm also open to anyone in WI and MN (open to others as well) that do installs. I'm not sure this service is offered anywhere. If anyone has any recommendations...

Just wanted to say thank you Terry and Tim. It was a pleasure talking with you about my setup. I realize your very busy but when on the phone I never once felt like that was a factor. Thank you Terry above and beyond is a understatement. My questions could have been all answered in a few...

I'm excited going to take my son for his first ride ever. Oldest will be riding tomorrow with me. Thank you mother nature.

No two strokes or four strokes to be found just two lunger's and two leggers what a blast just wondering why mother's nature didn't do this during riding season.

I've always ran my track "tight" per Yamaha spec. Perfect high speed conditions to test today. It came out of hole like always strongly 10.8-10.9k rpm but fell on it's face around 65-75mph. Rpm's dropped to 10.3 to low and would climb slowly it wasn't right. All that being said it's the...

I installed skid did fourth wheel swap. I never serviced inside guide wheel. Two old wheels got new bearings and moved from outside to inside. Third wheel was junk. The new wheels were installed on outside. I did track adjustment finally started it up to check it found the problem at this...

I did find the link in the search on how to do this only thing I didnt find was if you have a power commander. I'm guessing before I make the adjustment I need to disconnect power commander the "T" I'm going to call it and hook harness back to stock for a short period to perform adjustment...

Has anyone set up there apex to run grass drags? I'm seriously considering doing this. I'm not looking at a big investment at this point. I'm leaning more towards stock setup. I'm thinking chain suspension down leaving 2inches of travel per rules. I also think? that stat needs to come out...

I did do some two up riding not sure if this caused this. I did look at skid could not find any cracks. Thinking I may need to pull skid and get better look. Thoughts?

My season is over. I finally got 10k on the time clock best part was I was pushing triple digits when I did it. 3hours 26mins I gained another 115 trouble free miles on the apex to end the season only meet 4 sleds on a Friday

Starting point bear trap. 8,43,431,88,8,888,89,8. Ending point bear trap. 115 miles later:)

I'd like to get the nose of my apex low to the ground. I have coil shocks up front. I've had no luck with what I've tried. Ice is setting up nice in my favorite area to make sum runs. What I'm thinking about doing not sure if or who dose this. Can shock be lowered? Can I run a shock from a...

I'm in this will be my second TY ride. I will be UP there Friday am if anyone wants to ride. I will be leaving from Green Bay WI am have room for another short track sled if anyone needs a ride can an will pick up within reason. My sled fits snug at 136. I will see you up until then

I'm thinking about adding a g force yam charger on my 06 apex for the season. I'm looking for people that have done this mod good and bad real world results. At this time not looking to do a SC or turbo. I'm waiting for the 50th I've always wanted to snow check a sled. I'm also in the market...

Starter is making noise hope its just the starter. It makes noise while cranking and did start the sled for two days. I did some reaserch should I be replacing start relay as well. I'm installing a used starter today

Watching footage from last week Tuesday through Friday:-o:letsnow:

I have a starter noise while cranking. The starter is currently working however from what I read in my search its probably on its way out. I can't see rolling the dice on a questionable starter. I think having it rebuilt would be the route to go buying a new one is out of the question...

I installed power commander and ing mod with Allen's maps. Before I installed them sled ran perfect all running has been on a trailer or in garage when red light would shut off before install sled ran fine now when light turns off I have a low idle and it stalls. Do you think adjusting idle...