Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.
in the near future im goin to replace the ripsaw on 2011 xtx... does anyone have any insight or thoughts on the
Camso CrossOver Cross-Country 144x15x1.5 ....tired of all the spinning...im open to other track as well ....any recommendations on a good traction track
thank..
to all the gurus on here ... had these 2 codes come up the other day ... according to all that ive read on here last night ... everything was pointing to a bad bearing . i replaced the bearing with a new one this morning but the old brearing was as good as the new . how possible is it that it...
say I were to install a water temp gauge on a 2011 apex xtx....and I screwed the probe into the thermostat housing where the temp light switch is..... well it work....or well it cause the engine light to come on or give code of some sort
good day...what is the correct size of adapter is used on an 11 apex … all new to me ….ive read a lot of post but didn't see any that mention of adapter size...thanks
quick question people..... I'm wonderin what you do with the 2 small vent lines that run into the back of the stock air box when installing a hurricane CAI...thanks
does anyone know where to get a good vent kit... i like the evo kit with the bigger mesh and carbon fiber cut outs but there site is a lil screwed up rite now...some virus #*$&@ on there
and the saga continues....first belt gone at 300 mile....put a new one on and pussy footing around for the last 400 miles half afraid to punch it in fear of belt snapping again....sled was serviced and clutch alignment was all checked .... dealer says all was good with clutch setup last Monday...
good day folks .... quick question ... how tight .. ft - lbs ..are you tighting down studs when installing them..... single ply stud in a two ply track.... thanks
just wondering if anyone has any experience using rivet nut to install the belly pan on there sled ..... i have a new panel to put on and I'm on the fence of using pop rivets or rivet nut.... thanks
I have a hurricane tune coming very soon...this is my first turbo sled...now,if you were to choose one tune and one only,...which one would you choose and why... strickly for aggressive trail riding,few twists and turns...91 fuel is not a issue around here
has anyone have any issues with sway bar rubbing body panel on sidewinder....had a 14 viper and the sway bar wore a hole in in the panel...was sizing it up on the winder and there doesn't seem to be a lot of clearance on these sleds also....thanks
has anyone used single ply studs on a two ply track on the sidewinder...wondering bout the size of the heads that will be in the track of the idler wheel.....will it hurt the track/wheel and any noise created from this........wanna stud but havin a hard time with this....thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.