Search results

Looking at a new GT with EPS. Wondering how well it works and if anyone with real world experience could comment. I ran a thread search and found pretty much nothing on the subject. Thanks.

Tonight my flasher is not showing up on my phone. My gps shows up but not the flasher. I have unplugged it multiple times to no avail. When I turn the ignition on it flashes green a couple of times then slow blue flashes. Any suggestions?

All, My memory isn't what it used to be so I need assistance. Do you have to load the tunes into the GAP app on your phone or are they in memory of the flash tool? My sled has been in the shop for months and I had to get a new phone and lost my old data. I've looked through my emails and cannot...

Has anyone ever considered or attempted to install a r-motion in the pro cross chassis? Most folks seem to think the r motion is smoother, transfers better and is easier to adjust.

I developed a vibration at the end of last season. Dealer has had my sled for a while and I asked them to check the bearing since many have had issues. Sure enough its all shot. Problem is the parts are back ordered. Has anyone else run into this recently??? Also had my speedo sensor fall off...

Seeing a lot of sag on my sled. Most all miles were carrying fuel and gear on the back so shes hanging pretty low. Looking at the Hy Gear torsion and center shock springs. I like the idea of springs set up specifically to my riding style but wondered if anyone hear has tried them? Any input...

I did several searches and didn't find a definite answer. 137 inch skid, which hole is the stock location?

Driving along in Quebec and my dash flashes and I have code sd 42. Speedometer says 261mph. I also developed a horrible chassis vibration during the trip. So bad my hands were numb within 30 min riding. Also have no reverse now. Had to add antifreeze and oil on this trip too. Another problem...

At least when I had all yamaha relays only the gauges didn't work after a warm up then shut off to work on a non starting doo. This year with Polaris relays the fuel pump and gauges were out. -9f but this still sucks. Relays should not freeze. Had to pull them and warm em up.

Guys, I was checking my offset with the Hurricane tool and noticed something that doesn't look right. Are there supposed to washers between the helix and the secondary on the studs? It doesn't look like they should be there but the previous owner may have put them in. Any Idea why someone might...

Got everything installed today, wired in and organized. Put in my new Thunder primary rollers as well. (Anyone ever add o-rings under the nut to eliminate the slop or is that a bad idea?) I ended up velcroing the flash unit to the top left side of the fuel tank nice and close to the main plug...

I was doing some routine maintenance on the primary and I found one sticky roller. After some investigation I noticed the bushing inside the roller has shifted to one side and protrudes out past the sleeve. I tried tapping it back in and pressing with a vice but no luck. Does anyone have a trick...

I read in the GAP instructions that leaving the flasher connected can drain the battery. I was wondering if that was accurate and if we have to pull the flasher if leaving the sled parked overnight or longer? I recently installed the setup and and went out today to finish things up and the...

So my sled has been in the shop for over 2 weeks now since returning from Quebec where all riding was done in temps under -6F. I had run into the sd26 code, frozen relay for the dash display, bad miss and backfire under load and a broke seat heater. They found the inter-cooler had...

Anyone have or make a better set of tools to make spring adjustments to the qs3r shocks than what comes in the tool kit? They suck. Sent from my SM-G900V using Tapatalk

Does anyone else get a scent of oil smoke coming from under the hood after riding for a while then idling? Has had the smell after any hard running and then stop to wait for the rest of the group. Wondered if it is normal Sent from my SM-G900V using Tapatalk

Is there a fuse somewhere in the heated seat circuit? All my fuses are good but the seat won't heat. Yes it is plugged in. I traced the wiring harness but can't find a fuse. If anyone knows where the fuse is please let me know. Sent from my SM-G900V using Tapatalk

I did a search and found nothing so I thought I would ask. Has anyone used this adjustable secondary? Spring tension can be easily changed as well as the helix angle all without removing the secondary from the sled. Looked interesting. You would be locked to their components for helix angles...

I want to hook my ridelite to the visor plug harness on my Sidewinder. That circuit has a black wire and a red/blue wire. Which is the positive side? I've always thought a white wire was the common but this is obviously not the case since there isn't one. If anyone knows for certain which side...

Had both sleds in the garage today getting ready for snow and did some measuring and observing differences in their layouts and here is what I noticed, if anyone cares. 1) I would have bet from looking at the sleds the seating position was higher on the SW, it isn't. They measure the same from...