Search results

https://photos.app.goo.gl/ZBc8AaWXV9P5DmhD8

The stock 657x the boat came with was rated at 80hp so I thought why not?. Specially when the owner told me the boat was on its 4th or 5th engine. I really wanted to put a Yamaha Nytro 1049cc engine into it but I couldn't find any that were cheap

Well first ride out on the water went terrible... Couldn't get the engine to go past half throttle. I had a feeling from all the issues I had last year I hurt the engine abit and when I checked the compression when I got home It read 80psi on PTO side 110psi on MAG side. Cylinder walls look...

Yamaha exciter 570 PSI performance pipe installed. First run is gunna be the pipe pointed up just to make sure everything works than I'll make it hook up to the original exhaust.

https://ibb.co/s9HzNhXhttps://ibb.co/s9HzNhX

https://photos.app.goo.gl/QkRtRcTYPuMZ9cwQ6

Update: winter is coming to an end so I'm thinking about boat season already. Found a performance PSI pipe for the 570, I'm ditching the seadoo exhaust. From what I read this exhaust should squeeze out some more power. Also found the cavitation issue it was coming in from the driveshaft bearing...

Replaced that pivot and loosened the track but I still feel the vibration.. I was only able to run it up and down my street so about 60kph

The bolt ended up walking out of this pivot. I hope this is the root to my issues. There some idler wheels that have shot bearings but still roll fine and not a super amount of play

I saw that as well! Mine are not as bad as the pictures I saw but they are definitely not perfectly round anymore. But once your going above 60kph/40mph those wheels are moving pretty fast so it probably doesn't take much.

The sled has 10,000km on it but I believe the track has around 3-4,000

Hey guys have a question, my wife's 07 phazer GT has a harsh vibration I thought it was just the belt so I replaced it and still same issue. Drive and jack shafts look okay no wobbles, Track alignment and tension are good. Only thing I can find is some of the boggie wheels are oval.. not a...

Did you end up finding the issue?

So... After overheating the sled to 228 degrees, I pulled the sled Into a parking lot and removed the headlight and put it into my backpack and continued riding and never saw the overheat light come on again.. so I'm gunna buy a small LED light bar and install it in its place to allow more air...

So... After overheating the sled to 228 degrees, I pulled the sled Into a parking lot and removed the headlight and put it into my backpack and continued riding and never saw the overheat light come on again.. so I'm gunna buy a small LED light bar and install it in its place to allow more air...

So... After overheating the sled to 228 degrees, I pulled the sled Into a parking lot and removed the headlight and put it into my backpack and continued riding and never saw the overheat light come on again.. so I'm gunna buy a small LED light bar and install it in its place to allow more air...

Greeeaaatt..

Yes I'm aware of the damages of using a pressure washer on electrical components... Yamaha uses alot of connectors that arnt weather proof or sealed. That's why I used dielectric grease to prevent corrosion and water which is what it's designed for. I'm asking if car washes recycle water so I...

Hello all! I own a 09 nytro xtx and a 07 phazer GT I don't own an enclosed trailer...bummer, I have a open deck with a salt shield and both sleds have OEM covers. After each haul I do I will stop off at at car wash close to my house and powerwash all the salt and ice that collected under the...