Recent content by 4strokerpms

2006 apex with 12000 miles on it. Was almost impossible to start when cold and would stall when warm. Adjusted valves which were way off and sled run like new. Thanks for the write up. One note timing was a pain in the #*$&@ to get right after putting camshafts back on . Would probably try the zip...

I just put snow trackers on 2015 viper ltx dx and night and day difference from stock.

ground blocks Had the same thing happen to me. No codes but would crank. Check the ground block by the clutch on the main wiring harness. There are multiple posts about this on this site. Good luck.

cold start I wonder if this has to do with the iac valve? It has coolant lines running to it and from what i understand should that plunger mechanism move to let more fuel/air mixture in when it is cold. My 2006 apex gt with 8000 miles does this rough idle for about 2-3 minutes when it is cold...

iac valve cleaning If you plan on cleaning the iac be carefull on what you take off. The two lines going to the one end of the iac have coolant running through them. When I took of the bottom one coolant poured out of it. It is better to leave those lines on and unscrew that front part off...

link Sorry I forgot to add the link here it is http://durafix.com/

link Here is the internet link to order dura fix. Hope that helps.

starter Look on the royaldistributing.com website they are much cheaper than that. I don't know if they ship to the states.

Ground Block Thanks for the post. I have a 2006 apex gt and after a 40 mile lake ride it stalled on me while i was getting the ramp on the trailer ready. I got no codes on the display and when i turned the key my high beam indicator would light up. Got it started a few minutes later and the...

fixed Figured out my no start issue. Turned out to be the ground block by the primary clutch. Thanks for the helpful post on it.

I am also having a no start issues with my apex. Does the fuel pump cycle as it normally does when u turn the key? My doesn't. In my attempt to fix it i did find that my ground block on the clutch side towards the front had some burn marks in it. I took the block off and joined the wires...

I hope that somebody can help me. Problem started last week. I just finished a 40 mile ride when i got off the sled to load it on the trailer. As I was pulling the ramp the sled stalled. I went to turn it back on but all it wouldn't start. Let it sit for 5 minutes and it started fine. Trailered...

I hope that somebody can help me. Problem started last week. I just finished a 40 mile ride when i got off the sled to load it on the trailer. As I was pulling the ramp the sled stalled. I went to turn it back on but all it wouldn't start. Let it sit for 5 minutes and it started fine. Trailered...

scratchers Which scratchers are u using. The rail ones or ski ones?

relay I had a similiar problem this week. Came back from a ride, got off the machine to get the ramp ready on the trailer and the snowmobile stalled. Went over to start it and heard a slight click but the engine would not turn over and got a check engine icon with no code. Let the sled sit for...