Recent content by bigreis

I have the Grizz Tracks gusset kit in my 09 sub-frame. I hit a small rock going about 30 down a trail and the subframe twisted at the upper a-arm mounting spots. I got it straightened out again (8 ft piece of 1-1/8" cold rolled round bar levered between the a-arms with a ratchet strap...

I lost a few of the Dzus panel fasteners in the snow during a belt change at night recently. Just wondering if anyone knows how the length of these things are measured? Amazon has several different lengths available and I want to make sure I am getting the correct one. My guess is I should...

What have you guys found to be the best trailer locks? I bought some Master Commercial ones about 5 years ago and ended up using a bolt cutter today to get them off as they wouldn’t unlock anymore. I was really surprised at how easy a cheap Harbor freight bolt cutter went through them...

Thanks again for including us on this Tom... it was great to see Steph tonight. The swag bag made it worth seeing you too!

I'm hoping to be there Tom... thanks for making arrangements!

I have attached two data logs from yesterday... one at low speed because I am wondering if my aft is something to be worried about at low/no boost condtions. Second is a pull from rolling start to full throttle. I can't recall if I got the hesitation I am usually seeing on this run...

Just wondering if anyone has tried swapping the front skid shock and spring from an 07 vintage Apex RTX skid into an 09 Nytro XTX skid? Only reason I am asking is my front shock is blown out on the Nytro and I have a complete Apex skid available for parts. I can see that they are different...

I do have the POD and 550 injectors. I will post some data logs I took over the past weekend later tonight. Thanks for the reply.

I have about 1500 miles so far on my 09 Nytro XTX with a Push Turbo. This is my first boosted sled and overall I am impressed except for a hesitation when going quickly to WOT. I am running 6 pounds of boost, PCV with maps direct from Push, clutching from Push, etc... I was thinking of...

Tired searching but wasn't successful... wondering if anyone knows if the bearings on the stock upper idler wheel bearing are replaceable and if so, what size are they?

Looking for a more permanent solution now... those of you with rear snorkels are they aluminum or silicone tube? I could see an advantage to silicone in the event of a roll over, but not sure if it would be rigid enough to not flop over on big bumps or high speeds. Also, are the snorkels...

$7 at the local hardware store = problem solved. Looks absolutely absurd though!

The intake on my turbo is clogging up with snow within 30 seconds of getting into fluffy powder. I am looking for ideas for a quick bush fix as we don’t have conditions like this often and it totally sucks not being able to enjoy it because the sled will almost die due to air starvation. I am...

Do you happen to have a picture of where your 5 gallon mark is???

Haha... it's not THAT embarrassing! I just don't want to be one of the guys pissing landowners off with obnoxiously loud sleds.