Recent content by gpxsrx

Then ran hose out side of bulk head

Here is where I put mine with a 18 grease gun hose

This is what you need to take slop out

https://www.mainwaysolutions.ca/ The steering pivot is the problem

I do have a quite Hurricane muffler I’m going to install just have to send PC5 to Dave@ Hurricane to change the mapping.

No person shall drive a motorized snow vehicle unless it is equipped with a muffler in good working order and in constant operation and no person shall drive a motorized snow vehicle which has a muffler cut-out, straight exhaust, gutted muffler, hollywood muffler, by-pass or similar device upon...

I put the heavier side up.

Thanks for the heads up.

Thank you

Thanks I just got around put front coils on today. Noticed in your picture that the coils look like they are upside down I don’t know if that will make a difference or not. I looked up images of 2021 yamaha SRX and they show the tighter coils at the top of the shock. I’m guessing it only matters...

Put a set of 2019 srx dual rate front coil springs on my viperwith QS3 shocks looking for a measurement for preload. Thanks

No just rivets

What I did is drilled out added 18” grease hose and put outside. Never replaced plastic bushings but helped. Next summer I will do your brass kit. Very nice job.

I changed my stk front end to a Zbroz 45” looking at SRX front coils to lower my front end on my Sr viper. I’m using QS3’s and want less pre load on front coils.

Thanks Travis that’s what I did.