• We are no longer supporting TapaTalk as a mobile app for our sites. The TapaTalk App has many issues with speed on our server as well as security holes that leave us vulnerable to attacks and spammers.

Recent content by jrice1987

  1. J

    Impeller seal?

    Which way does impeller seal go on water pump black up or white up?
  2. J

    Impeller seal?

    Is this the right way for impeller seal to be installed?
  3. J

    03 rx1 popping and burble?

    Hey all, got a little burble at 1/4 throttle. Ive read older posts that this is common possibly lean symptom. Also if I run do a wide open run it pops a little on decel. Note: though the previous owner did gut the exhaust. Would this cause the burble to be more audible along with light poping or...
  4. J

    Asap question just after replacing exhaust donuts

    I just tried again and it and after 30 sec of closing them off it died
  5. J

    Asap question just after replacing exhaust donuts

    So I just replaced exhaust donuts with copper ones and put rags over exhaust. The sled almost completely stalls out but does not. New donuts not sealing? Should it stall shut off completely with rags over exhaust?.
  6. J

    03 sx viper shock in 03 rx1 skid install

    So I got the 03 sx viper shock. What all is needed to install. Spacers, bushings, bolts, are they the same as the original rx shock?
  7. J

    2003 rx1 muffler can gasket install

    Is there any tricks to installing the muffler gaskets in between the the y pipes and muffler can. They seem pretty fragile?
  8. J

    Shock identification needed!

    Guy I'm looking to buy from says this shock came out of 03 rx1, has a pioneer performance sticker on it revalved sx viper shock I presume, bushings do not look the same? Can anyone verify this will work in 03 rx1 skid, and is it worth rebuilding the shape it's in? Thanks
  9. J

    05+ mono shock in a 03 rx1 proaction?

    Thanks fellas
  10. J

    05+ mono shock in a 03 rx1 proaction?

    Will a mono shock fit in a proaction skid, to long to short....
  11. J

    track sag on 03 rx1

    What do you guys run for track sag on rx1?
  12. J

    03 rx1 lean condition...?

    Ok thanks guys, I sprayed it down with carb cleaner no vac leaks just makes me worry it was 28 degrees out and and tip was was turning gray worried about when it gets colder, the insulator part is still black though I dunno.
  13. J

    03 rx1 lean condition...?

    Not real long, couple real good rips across the field, shut down to check plugs, you think it's just the black crap burning off, the plugs are not that old, would stabil do this?
  14. J

    03 rx1 lean condition...?

    So we got a little snow and I took er out for a test spin, it seems that I have a lean condition, plugs were black, now they look like there tuning white. I have even raised the needle still didn't help. Floats set to high end of tolerance.


Back
Top