Recent content by thetruck454

It's not a sealed bearing. The side to the bulkhead has a separate oil seal pressed in the housing and the side towards the chain case is open to get the chaincase oil on it.

In the middle of doing all the bearings for the first time at 12k miles and the last one is the jackshaft bearing pressed in the frame/bulkhead. I knocked out the old bearing and it feels as tight as can be, but the new one rattles slightly when you shake it. Think I got a bad one?

My dad's '16 Vector XTX does not want to start or idle when it cold. It acts like an old carb engine where you have to play with the throttle and keep rpms up for a while. If it does stall it does not want to start, catching and stalling repeatedly. When it does fire up again the rpms...

I bought the sled new and have never changed em

Nytro has just under 11k on it. I'm assuming that wear on the primary shaft is normal, but when should I replace the bushings/spider rubbers? I'm on my second clutch kit so springs and rollers/weights are fresh(ish). I've also replaced the buttons/spring on the secondary recently.

That makes much more sense. Thank you!

My father has a '16 Apex XTX with the upgraded fox shock. I sent it out to Hygear for a rebuild since he's sitting at 7600 miles. I've read the easier way to get it back in is to let the air out of the main chamber. Now for the embarrassing question, where is that? Looking on Fox's diagram I...

My '09 Nyro XTX has 12,000 on it and since its my wifes and I don't ride it, I figure its time to replace all the bearings. I have the parts ( I tried to get all new circlips and oil seals so if/when I mangle one getting it out) underlined in red below in my "cart". I'd rather not get part way...

Does this torn rib mean this belt on its way out? There are a couple other spots that fabric is worn on the peak of the inside ribs, but no other missing rubber. I measured the width at the valley of the outer ribs several places around and got 33.4mm-33.7mm so within the 32.5mm spec...

I have A-arms, skid plate on both my Nytros and just ordered his running boards for one of em. Quality parts that are well worth the price

Did anyone ever figure this out? I have a '09 Nytro xtx that I've had the skid apart almost every year (so who knows if I put it together correctly) and I have it set up like option "B". I just picked up a '14 Nytro xtx and its in configuration "A", but unknown if the previous owner had it...

The gauge is off a 2012 Vector with EFI and EPS so it is the correct one. I figured out what the 8th wire was for the EPS error signal. It tells the gauge to illuminate the EPS symbol. Here are some semi finished pictures of my gauge swap. I added the aluminum bracing because the weight of...

Thanks everyone, I was able to figure out what I needed.

I have the vector gauge mounted and am building a plug and play wiring harness extension (https://www.corsa-technic.com has every single connect I've ever seen, it's a great resource), but have a question. From what I've read I need to add a single pin for battery power to keep the clock from...