Recent content by wyre345

No just 3 lines at the bottom of the screen

I have the dynojet pod on mine and I lost my reading for AFR. Any ideas?

My wife has a 2014 Apex xtx. In low snow conditions the yellow caution light come on that it's getting hot. But my old rx1 wont get hot in the same conditions. Is the light warning you before it gets too hot??? And I also read that it will shut down before it over heats. Is this true?

Thanks. That helps a bit. Would really like some measurements to help me along alsi

I would like some measurements also. I'm going to do a swap in my 05 rx1

Does anyone have info and measurements on doing this skid swap. Would appreciate any help.

Found the problem. Broken wire at the connection of the TPS. I guess it was 2 long and one short flash.

My rx1 is flashing the engine icon and caution light 3 times. This code means thumb warmer switch but seems to be working fine. Will it harm the machine to drive it like this??? I know a couple of times I have gotten a shock off of my one hand grip. They are worn out pretty bad. Any help would...

I blew my chaincase last weekend and I limped it out of the bush. Fixed everything now but my engine light is flashing. Started when I blew the case. Any ideas??? Could it be my speed sensor???? It's not chewed up but was very close to the gear when I got the machine home. It blinks 2 and one...

If it is a bearing with a seal on both sides can I leave them both on???

Thanks man

I'm doing my rx1 chaincase bearings and I have read that on the bottom drive bearing some recommend leaving the seal in the bearing toward the oil to keep the filings out but to cut a little slit in the seal to let oil in. Do you leave the grease in the bearing also???? That's my question. Any...