Recent content by Yammer on the Rock

They are the same donuts so should not be an issue. I have 11,000 km and on the original donuts and no leak yet though have had steam on a couple of occasions. While you have it apart might be an idea to remove the servo and check the reverse levers and gears for lubrication. There are a couple...

If you have the rear seat you first have to remove the plastic trim, think it's 4 10mm screws then two bolts of 12mm to remove the rear seat. The front seat is two 12mm bolts on the side of the front seat plus three plugs in's for lights and stuff. The tank is held on with two nuts and a couple...

Condolences to the family.

240 should do it for you and at a lower weight. Enjoy

If it works post a pic, been wondering if I could upgrade again when my CH croaks.

If you are looking to upgrade your Phazer, MP or VL to a little more cranking power try a YTX20CH-BS been running one for years after the OEM YTX14BS packed it in.

YTX 20 CHBS

Here it is great fit

Digging out today going to pull off the panels tomorrow morning, the sled was outside and we got snow, rain, snow, and 100km wind -13 windchill wicked.

I can get a couple of pictures to give you an idea of how it all fits. Will get as soon as it stops snowing.

Yep block off the exhaust but no big deal if you have to get into them I have the tank and seat down to 10 minutes. Got lots of practice checking my Gearbox Servo.

I upgraded my battery a couple of years back, it was a little higher, and other than that worked well. I can pull off the side panel tomorrow and get the info. YTX14BS is really lacking in Cranking Power.

Excellent write-up and a project for later. I have been having issues with the infamous lashing green light so looks like a way out. I pulled the servo and bench tested it and everything was great. Today I put the servo back on and tested it on the machine with jumpers and battery and it...

Is it possible that my flashing green light is caused because it is stuck between gears? Tried several suggestions today but no luck still flashing but will lunge forward under throttle behaving like a TORS engaging.

Have a 08 Venture Lite which today is having an issue with the Drive Light Flashing, wont go in forward and won't go in reverse, when I give it throttle behaves like the TORS is kicking in but no code 84. When I took it out of storage yesterday it didn't want to go in D or R and the only way to...