Search results

03RX1- I did manage to get a wire down through the pilot jet, though not a bread tie as has been suggested on here. It was a wire from a wire brush smaller diameter than a bread tie and stiffer too. I can see through the jet there is nothing like what you describe in mine.

ChrisRX1 You must be a little prescient, as yes I found a real live vacuum leak!!! Get this, not until the third cleaning did I notice that there was a hole in #3 Carb cap! Something 6-sided like a bolt head but small like 6-8mm punched a dent in the carb cap. Piece was still there and...

After cleaning again yesterday (a better wrench than I this time) we went out to test, still not right. He checked the TPS, doubting after more reading on here that that is the prob. We are going to remove and clean on the bench this time, and see if that does it. Much colder yesterday, snow...

Len, I am not getting any current at all from the TPS, do they go bad? The carbs were quite clean, very little at al and one Needle had a little crud on it, thats all. I use both cans and pump depending, I have put 7 gals in this season from fresh new can so.....

Hey guys I have an '04 Warrior that is stock as far as I know aside from studs and doolies. I have cleaned the carbs, reset the pilot screws put it all back together, cleaned the clutches swapped out for a new belt and went for a test run. My idle was always way low, like a cammed motor, so I...

Not to sound too stupid here as I have cleaned carbs before, but would anyone have a pic with arrows to indicate fuel screws? I just cleaned mine and would like to make sure all is well adjustment wise.