Search results

Only from 2011 and up they went with 1 1/2”. 2010 and older are same size as nytro, 1 3/8”

Why not?

Just for comparison mainly.

Hi, I have a 2017 sidewinder btx with a PEFI multimap with dash flash and a 2018 sidewinder ltx with a hurricane flash, unsure of what the exact stage is as I recently bought the sled and the owner knew very little about it. My question is, can I swap ecu’s back and forth from one sled to the...

The starter solenoid has been acting up on my nytro so I finally decided to buy a new one. When I went to swap out the selonoid, the new one has the connector going inside the selonoid coming off the opposite post. Can I just swap the terminals on the solenoid? Anyone else ever experience this?

Yes, correct. I'm use to working with pcv on my turbo Maverick all summer

Thanks! I will give it a shot

I was looking through boxes of parts I have kicking around the garage and I came across a msd 4350 launch master I had on my apex. Will this work on a nytro? If yes, what needs to be done with the 4th injector connectors?

Wrong

A friend of mine is chasing the same problem right now. His sled is a mcx 19t however. Next thing to check is fuel pressure regulator. I also run boost it with 16t mcx kit and I can over fuel my engine easily with boost it. Both out engines are pretty much same.

Zx2 I had the exact same bolt shear off on me. Very few miles on my zx2 as well. Funny thing is one if my friends also has zx2 on his nytro, his suspension would not compress at all over the bumps, not even a little bit. I would have thought he'd be the one breaking bolts but nope. Mine broke...

I am running a powderlites stage 2 kit on my 162" nytro. I run 14-18lbs boost at elevation and it pulls good. Only thing changed with my kit is it has the boost-it fuel system instead of rapid bike. Previous owner installed boost-it due to simplicity of changing fuel numbers on the fly to...

Is your nytro's idle set too low? I heard someone say one time that this can cause a stumble or even stall the engine.

Sled runs now and it was indeed out on timing. Thanks for all help everyone. This is the best forum on internet

Thanks for all replies. Timing being checked this afternoon and I'll post what the outcome is.

thanks! I'll check that tomorrow.

Intake valve clearances were tight but exhaust were ok. Double checked timing and it's good.

I have a mcxpress turbo on 2006 apex rtx. Recently put new intake valves in it and since rebuild, can't get sled to idle. Have to hold it full throttle while turning the key to get it to start and it runs rich until 3000rpm. checked codes through diagnostics at dash, no fault codes. Anyone have...