Search results

Some of you may ask why and I will answer. I’m board and not willing to give up my winder mtx. Wanna try something new but there is nothing out there that impresses me. Just stuck on 4 stroke power. So I’m converting a 2017 Sidewinder to a Kmod Skinny turn key suspension with the 165 alpha...

I have a MPI supercharger kit. The taper lock bushing inside the lower pulley broke in half. The pulley was damadged in the process. I need to purchase a new pulley and taper lock bushing and set screws. Does anyone know where I can find them.

I have a push turbo nytro. I have had it for 5 years with no problems. Now all the sudden it's bogging down violently. Backfires sometimes also. When it bogs down my air fuel mixture goes extremely lean. I also noticed that my fuel programmer lights are blinking as if it was shut off and then...

2012 turbo nytro is bogging down. Mostly at full throttle. Sometimes the sled will shut off. Every time it Boggs down I look at my fuel programmer and it seems to be shutting off and turning back on once I let off the throttle. My O2 sensor also goes full lean when it Boggs. It seems like the...

hello folks. I just made a huge rookie mistake. I bought two left side drivers for my driveshaft. I did not notice that the left and right side drivers are different. I'm guessing the only difference between left side and right side is the location of the alignment marks. I'm guessing they will...

Can I reuse my head gasket on a nytro. It looks ok I guess. Has anyone else reused a head gasket.

Hello. I just installed a supercharger on an nytro. It's the mpi stage one. We took it out an. After about 20 minutes on the trail the sled shut down. It also had a temp light. Sled wouldn't fire again. The supercharger seems to be seized up. It won't spin freely. The engine turns over but won't...

Last year my sled was popping out of reverse when I let of the throttle and making a grinding noise. Sounds like a loose chain to me. I'm just prospecting for ideas. Anyone have this problem.

Hello. I need a little guidance. Nytro won't start up. Fuel pump won't cycle. I checked the fuse and it has no power. I also have fault code 43 flashing. Which is fuel injection power or something. I swapped the relays by the ecu. I also swapped the ecu. Nothing happend.I tested the fuel pump...

Just wanted to ask around and see what air fuel ratio nytro riders were at when WOT. I'm running about 12.5 I would like to lean it out just a little more. Just want to see what anyone thought. I don't want to lean it out if it is going to cause me trouble

Anyone know how to lower the idle on the nytros. I put a new engine and throttle body in an 09 nytro. Engine fired right up. Runs good and sounds good but the idle is high. 2500 rmp. There are absolutely no codes being shown. I have proper throttle cable free play. The throttle body has not been...

Just wondering if I should try the dayco xtx performance belt. Or any aftermarket belt for that matter. I have been running a stock belt and it does just fine but just looking to explore new options. I have a nytro turbo. Running about 12 psi boost.

I have a 2012 nytro mtx with a push turbo installed. Its hitting the rev limiter when i have the throttle pinned. I'm not shure what kind of rpms I'm pulling. But I will make note next time I ride. On my secondary clutch I have installed the new helix that came with the turbo kit. I have the...

i have the maverick track on my nytro right now but its not gonna cut it. so its time to upgrade. i either want to get a camoplast powerclaw or a camoplast challenger extreme. has anyone tried thees tracks. i dont know which one to pick. help.

is there an idle speed adjustment for the nytro. mine all of the sudden idles at 2300 rpm. i think the trottle body solinoid (idle speed controll unit) is bad. has anyone heard of this problem. throttle cable is not hung up, nothing is unplugged.

wondering how to tune my stock nytro suspension for maximum powder performance. i do not have the fox floats, just regular shock and spring.

nytro mtx. i have a error code flashing. this code says the idle speed control valve is stuck wide open. how do i correct this

i have error code number 37 flashing. it started this year when i fired up the nytro. any one know how to reset theese codes.

fired the sled up this year and code 37 was flashing

2009 nytro flashing error code. any help would be sweet :yam: