Search results

I added some Yamaha fuel stabilizer and it seems to have fixed the issue, it will stay running so far.

I thought I will try it one last time, and it stalled twice but I was able to get it to run without shutting down for 5-7 minutes. Weird could be some water in the injectors .

No it does not show any codes and seems to only die after it is warmed up, then will not restart. Let it sit for 6 hours and it fires right up.

My 2007 Phazer Gt will not stay running , while riding this weekend is was boggy for the first 30 minutes then died on the trail. I brought it home and after it cooled down it fired right back and then died 3 minutes later, and then will not start until it cools down again. Any ideas?

Would the axel bearing be a wobble bearing, that might let it flex a bit?

I just purchased a used 2015 Viper ltx with 7300 kms and discovered the previous owner blew a driveshaft bearing on the left side inside the brake caliper. Should I be concerned if he did not replace the chain case side bearing(right side of axle) that would have been stressed from the axle...

“ Please Enter Me in the Raffle”

Stock Fox Float 2 rear shock

Thanks guys I changed the front shocks to 65 psi cold and the rear to 165 psi cold and it rides perfect, some inside ski lift but that i can deal with

What pressure do you recommend to run in the Fox Float 2 front and rear shocks on an 2011 Apex Se?

Last 2 rides I have had the "check engine" light & triangle warning lights come on with code 84 flashing. It slows and limits RPM just like TORS. I think it is TORS. I can ride for 15 mins with no issues then it happens and I have to wait 30 secs by the side of the trail for it to pass...

My 2007 apex runs fine for 20 minutes and then the engine light will come on and the engine will surge down to idle, the light flashes 12-17 times and then goes out and it runs fine for another 20 minutes. It seems to do it mostly once you let off the throttle. It does not seem to be showing any...

How would you proceed to syn an Rx-1 with 4 carbs, only two carbs have the vac lines attached to them and the other two are capped off?