Search results

Same problem here. Trying to figure out why it only lasted couple hundred miles, before the rattle came back.

Mine cracked as well. Warranty

So what is the secret installation tip? My rattle came back and I will tear it down to see the results next week.

After 400 miles, clocked since instalation, rattle is back. Plan on checking it out more carefully at the end of the season to see details.

New 23 SRX. 0 miles. Removed stub shaft and added the "knockout kit. Reassembled with the green loctite, and I installed hub assembly Still 63mm offset. Now if I remove the 2mm washer behind the secondary, next to the jackshaft circlip, it will bring me to 61mm offset. What offset is every...

Well then, l have to say this has been a Murphy afternoon trying to put this kit on. Even though the shaft and shaft housing were clearly marked, these splines would simply not line up. Probably because of the grease. I was ready for a Donnybrook because I lost my afternoon nap.:die Mine had...

Just checked my new 23 and found 63mm offset. Going to remove and reset stub shaft today and see where it brings me. You would think after all these years there would be some consistency

Thanks. Much appreciated.

You do these?

Haven't tried that yet

Does anyone know if the wire connection heads on these shocks can be removed and reversed? Not a big deal but the stickers are on backwards on these shocks and if I swap the shocks to the other side, the connectors are in the wrong configuration to be mounted.

I ended up with the Yamaha Mountain ski. Tried C&As, second choice, and pilots. Not a fan of the dual carbide set up. Too much push in the orders. Oddly enough the new Stryke ski has a similar deep keel that the Mountain skis have. I'll try those out this year. Ran the snowtrackers with all of...

Angled vs flat. Thinking of using the double angled backer plates on my studded track for trail riding. I've only used them in the past for my hot rods on the track and never on the trail. Anyone ever use them for trail riding? Thanks for the feed back.

It's been a long time (12years) since I've studded a track. Been using prestudded with great success, even on my last Sidewinder. I'm leaving the 1 Inch track on the new SRX. I'd like to keep it and stud the track and see how this track performs this season. What studs are you guys using on...

Ahhhh ❄️SNOWMOBILING❄️ MORE ADDICTIVE THAN COCAINE BUT TWICE AS MUCH MONEY

This SRX came with a big cargo bag in the back. What' are SRX riders using for extra fuel? Do I need to switch to a smaller rear bag? There is quit a difference in available tunnel between the 2.

Thanks everyone. I do have the heavier rate spring from Arctic Cat that I used on my previous Sidewinder. Hope it works if I need it. Does anyone know if it will fit the SRX?

Question for all you SRX riders. Will this machine need a heavier rate spring on the front shock, rear skid? I needed one on my 2018 Sidewinder LTX. I am a 210lb rider.

I've been using the Yamaha Mountain ski's, for a few years and they work well on the Sidewinder, for that type of riding. Pair them up with a set of snowtrackers and they perform excellent on the trails as well.

Doing the Star Suspension Kit installation and was wondering which hole does the lower limiter shaft go in. 2012 Apex XTX. Instructions are not the best.