Search results

I have no visible leaks on the case side. Could it be leaking from one of the shaft seals? I changed the case oil two years ago. I did not ride much last year due to lack of snow, and I put on around 600 minutes the year before. I did change the top gear two years ago when I upgraded to the...

I'm looking at parting with my nytro XTX. I was planning on a sidewinder of course, but last weekend in MI, I had the opportunity to ride both the sidewinder and the Polaris assault 144. Obviously the winder has more power, but the Polaris handled great, and the model with the 2" track hooks up...

While changing the track and bearings on my XTX, I noticed a mouse had made a nest on top of the head the engine. I pulled the fuel tank to check the wiring, and I found one blue wire with some of the coating chewed off. The wire looks like it is for the fuel injection system. I taped up the...

Hi all! Happy New Year! Im in the process of doing a track change on my 2012 xtx and i discovered my jackshaft bearing in the chaincase was getting a little rough. I am going to change the drive bearings as well. My concern is with the jackshaft bearing on the clutch side. Do I need to pull the...

Im in the process of installing a backcountry track on my 2012 xtx. I have everything out right now. I am planning on removing the tunnel protectors, but I would like to leave the last section of one of them in at the very back of the tunnel. I have my tail light re-routed and my wiring is...

HI all, I bought a snowmobile lift at haydays to do upgrade to a backcountry track on my XTX. I'm wondering where that lift should be placed to prevent any damage. I would also like to change my oil while I'm in there. Is that possible with the lift under it?I know I have to remove my skid plate...

Hi all! I have been looking at some headlight options and I came across some xenon gas bulbs were interesting. Also I have been looking into LED lights to see if they are an option. My question though, is the wattage of the stock headlights. I am curious of the wattage and draw on High/low beam...

On a2007 apex attak, what should the engine rpm max out at when at wide open throttle? Also getting codes 22 and 84. Any help would be appreciated....

Hi all, I've been looking at a 99 triton elite 101 enclosed trailer (4 place). Anyone know if my xtx will fit in this? Worried about the height, not so much the length....

Hi all, I've been looking at a 99 triton elite 101 enclosed trailer (4 place). Anyone know if my xtx will fit in this? Worried about the height, not so much the length....

Hello again. I relocated my tail light on my XTX so it is no longer on the top of the tunnel. I have an exhaust turnout also. When I was at the snow show this fall, i took a look at the viper tunnel sacks and got to thinking they may mount quite nicely on the tunnel of the xtx with the light...

Just a question, I have my limiter straps in the middle setting and have max preload on my center shock. I also have all of the preload off the springs in the front shocks. I ran this set up last year with my torsion spring on the middle setting for most of the season. I did set it to soft later...

Hello all! I have a 2012 nytro xtx and have done a few mods to it mainly for trail riding. I do hear and see a lot of comments regarding the poor performance of the stock handwarmers. I am wondering if this problem was resolved by 2012 or if it was still an issue. My warmers seemed to work fine...

I have a 2012 XTX with about 2200 miles on it. When should the drive bearing be serviced/replaced? I f that bearing is servicable, is there a specific grease to use? I just purchased my sled last season and want to make sure it is ready to go. The sled has the 1.25" track....for now...... Thanks...

I was wondering if anybody has used this coolant boost in their snowmobile coolant. If so, are you satisfied? Or is this not recommended? Any feedback would be great!

Just wondering what a guy has to do to remove/replace the front inner idlers on a nytro xtx....im thinking you have to remove the front shock from the top mount, I took all of the preload off of the spring. The skid is on the sled yet.. Im adding 4 "X" wheels to the rails. I already have 4 ski...

Hi all! I purchased a 2012 Nytro XTX last November. It only had 648 miles on it and it was the first sled I had owned in about 18 years or so. Last season I started with tuner skis and dupont sliders as the first upgrades. I never thought I would end up putting on roughly 1600 miles in my first...