Search results

All 2017 SW with TD tune with close loop with 15K mi. I recently added clutch weight due to slightly over rev. Note I may have turned clutch CW when adding weight not sure. After weight was added did small run around field but it was not a long enough runway test fully but seemed fine nearest I...

All I have what I believe is a O2 sensor failure that is used with the TD closed loop set-up. This is will be my second failure. At idle AFR dash reading is 14.9 then jumps around 20, 30, 40, ….. Looking for Robust or equivalent replacement part# and if handy recommend place to purchase. Thanks!

How are the Winders performing against the 900R and others? Someone must have lined them up by now! stock for stock and tuned?

What should I read for resistance when across the terminals of the reverse actuator? I am getting SD-8 error code when measure voltage I do see a 12 volts for a short blip when pushing the button

part# help! the bolt hole oblonged and the bolt missing from rear skid. Looking for part# for the bracket and bolt. Looked at the fiche but unsure. It’s the right side when sitting on the sled. Rear skid mounting bolt and bracket. Also is the bottom hole okay to use? If so how does this change...

Looking for shock/suspension recommendations for a 2012 apex xtx. I find rear really stiff and front could use improvement as well. All stock. 100% groomed trails. Can I get it to ride like or similar to a Sidewinder with the QS3R shocks?

I have a friend who has a 2019 xtx and when gas is at about 1/4 of a tank or less, going down hill and applying the brake, the engine cuts out and stalls or pops really bad. It started doing this the middle of last year and again this year the last two rides. There are two other sidewinders...

Are they worth it? Also I am confused about the correct part number. Is it SMA-DPSSR-00-00 which I believe are 144”. I thought the xtx was one 146”. I also heard that you should use the ones for the mountain sleds ( SMA-DPSSV-MT-00) and cut them down. The mountain version are nearly 2x the...

I have 2017 sidewinder 137 . I am looking for the next heavier size or two torsion spring part# from Yamaha or Cat. I am 230lb with gear and always ride with the Linq 4 gal gas with luggage bag. I have the BOP 4 slot adjuster and run it on 4. thanks!

Is the cobra 1.6” track a 1 ply or 2ply? Woody web site calls out 1ply for the 2018 and nothing listed for the 2019 XTX SE. For the 2018 XTX they call for Grandmasters 1.575”. What are your thoughts on Grnadmasters vs Gold digger 1.575” any reason the gold digger will not work or not recommended?

All I am considering updating my front shock on my 2017 do and I am looking for recommendations on what to get and best place to purchase. I get a lot of feedback through the handle bars and believe it the shocks. I rode a xtx SE this weekend it this rode better but still not where i think it...

i have 2012 Apex XTX and just added aggressive sno tracker I have a slight to medium push in the corners and think I need some add more ski pressure. Should I tighten up the limiter straps one hole or loosen front skid shock? Maybe something else?

All, Looking for the cleanest install for spare gas can on a 2012 xtx apex. Easy on/off and durable.

I have 2017 STX-DX with 5k miles 192 gold diggers 1.6” cobra track. I drove the sled with stock skiis with updated carbides for about 3000 mi. I adjusted the center shock up and loosened ski shocked loosed as much as I dare to go to reduce heavy steering and that help alot, tolerable but not...

Hi All, I looking for recommendationr and part# for: Tall windshield Bar riser 2112 apex XTX

I had a blown hand and thumb warmer fuse while ridding last weekend and I am curious if anyone else has experienced this? I . replaced the 20A fuse and was good for about 4hrs tlater blown again. I thenreplaced with A 30A for that was all I had . The warmers are still good after 8 hrs of...

I justt picked up a XTX figured I would post to the knowledge base for upgrade recommendations and things to to watch for. Thanks in advance .

Any one else notice their fuel gauge jump around 1/4 tick at a time on level ground? I seen this several times. I stop for a break look down see 1/2 a tank go a couple miles glance down again read a 1/4 tank . I think the resolution of the the gas gauge might be iffy.

which ones and where to mount? Pics...

rode today with 2016 venture and 2011 apex hardpacked trails early am. Apex no studs stock venture 96 studs. SW 192 studs . SW overheated several times. Apex and Venture no problem.