Search results

Is this the right way for impeller seal to be installed?

Hey all, got a little burble at 1/4 throttle. Ive read older posts that this is common possibly lean symptom. Also if I run do a wide open run it pops a little on decel. Note: though the previous owner did gut the exhaust. Would this cause the burble to be more audible along with light poping or...

So I just replaced exhaust donuts with copper ones and put rags over exhaust. The sled almost completely stalls out but does not. New donuts not sealing? Should it stall shut off completely with rags over exhaust?.

So I got the 03 sx viper shock. What all is needed to install. Spacers, bushings, bolts, are they the same as the original rx shock?

Is there any tricks to installing the muffler gaskets in between the the y pipes and muffler can. They seem pretty fragile?

Guy I'm looking to buy from says this shock came out of 03 rx1, has a pioneer performance sticker on it revalved sx viper shock I presume, bushings do not look the same? Can anyone verify this will work in 03 rx1 skid, and is it worth rebuilding the shape it's in? Thanks

Will a mono shock fit in a proaction skid, to long to short....

What do you guys run for track sag on rx1?

So we got a little snow and I took er out for a test spin, it seems that I have a lean condition, plugs were black, now they look like there tuning white. I have even raised the needle still didn't help. Floats set to high end of tolerance.

So I have a grounding problem at the ground coming out of the harness, (grounding block i assume) If i run a ground from the battery to hand warmers I get 12vlt and warmers work and blinking light goes out. Soo... the hand warmers, thumb warmer, and thumber warmer switch work off the same...

So I have replaced both hand warmers, switches, tried 3 cdi boxes, checked fuses, relays, the harness for rubbed thru wires etc. There is very little voltage at the power source it seems like, but I I tried 3 different did boxes nothing changed. What would be the next place to look?

I get the track aligned but as soon as I start the sled and rotate track a couple times it goes back to being 1/4 In off?

So what I thought would correct my issue did not...arg. I had a sloppy coil/spark plug wire, sled still runs burbly and backfires a little and idle is up and down a little afterreplacing all coils. Pulled all plugs,all are black, would stabil in the fuel make it run rich like this! This is...

I just want start off this forum has been a blessing, very helpful folks on here, thanks in advance! So I was looking at the alum bodied shocks and noticed a nut with a Phillips head, what is this for?

What after market could are you guys running, I've seen spi,kimpex,rm stator, not sure which to go with?

Has anyone ram this exhaust on hear, how does it sound?

So I was wandering how ya all replace the rear bulk bushings towards the motor it's so tight? Any suggestions?

So i hear the ulmer kit will work for the 03 front end, except the spindle bushings, what part number/ spindle bushings do I need to fill this void?

I just rebuilt carbs.... is it normal for gas to come out of of the main jet where the needle goes down in when i rev it? It does this on all 4 carbs?

Rebuilt and cleaned carbs on rx1 slight gas mist in mouth of all 4 carbs is this normal.