Search results

Going with a group to New Hampshire next week for a few days and gave my 2018 Viper a once over. I wanted to clean the clutches and with just over 7,000 miles my original belt was performing well and looked good visually, I turned it inside out and it was cracked down in between the cogs all the...

I still run the stock twin keel skis with 4 1/2" and 6" Stud Boy runners inside and outside respectively, love the hour glass shape as they hook up like crazy on the groomed trails. I just checked them and the front of the carbides have worn considerably with little wear from the middle to the...

Just realized on my 2018 Viper that I can display a numerical value on the coolant temp. bar at the same time, my question is, I'm normally running in the mid 160's, is that within acceptable temps, or is there cause for concern? I also just installed Dupont Sliders and almost always ride on...

Apparently there is a fix to the infamous Yamaha clutch rattle by putting 280 bearing and shaft loctite on the PTO stub shaft, I'm pretty mechanical, but, have never taken off the primary on my sled (2018 Viper), is it fairly easy and if so, can anyone walk my through the procedure? Thanks in...

Had to replace the starter relay on my 2018 viper and failed to make myself a diagram, there is a small red wire from a wiring harness that attaches to one side of the relay, I think it goes on the side with the large red cable that goes to the positive battery terminal cable but can't be...