Search results

Can you tell me if the dimples you are referring to are on the gear end or the opposite end and are they indeed on the very end or the surface where the lobes are?

DIMPLES? on the very end of the cam or on the lobe area?

both cams have only 1 ring. I did notice that on other models, does not apply to mine. Thank you for responding. I believe after looking at my pictures that I have it correctly installed.

Good day to all whom read my post. Motor is going back together and I am not sure if I messed up and need advice. I installed the cams, timing chains and I think I may have screwed up by not knowing which cams was intake side and which was Exhaust. Thought I had them labeled or set aside...

Started tearing the motor down today, getting to the pistons and rings. Cylinders look great, still have cross hatching on them. I haven't pulled pistons yet. If I remember on my Nytro I could get manuals sent to me. I realazied that I let my subscription last so doing that again. I am hoping...

engine Circling back on this thread. Today I performed a leak down test. Discovering that by doing so I have air coming up from the lower end of the motor through the cam chain area which to me points to pistons rings. Even tho the valve lash was done too I now know... Also discovered that I...

I think my valve are within spec, because if they warm up then they will swell past the .000 range.

I may have jumped the gun a bit because I did not perform a leak down test I went right to valve clearance. And I measured and will post the picture of my findings but I need to find the valve clearances and I do not know them. If anyone can help me with these measurements please do. Cylinder 1...

no I work too much, but today I have decided to pull the engine no matter what. Leak down can be done on the bench for sure. Trouble is my NYTRO I had to take the nose cone off that sled however I am am at point where the rear motor hanger bolt will come out and the motor will be free. Does...

THANK YOU, love this site!!!! Best money I ever spent!

Thank you, both of you for helping me out. 3 more bolts and the motor will be out. One more learning curve. My Nitro is slightly different but much the same. The valve train is where I will be starting and leak down procedure as well. I will let you know what turns up for me.

I have a 2007 Vector ER that when I bought it the guy said it would run better once it warmed up. Giving what I found I can believe that statement. I thought I had a carb issue, turns out after a compression check low on compression.... I started on the clutch side. 90 psi, middle 120 psi and...

WRENCHING

Thank you, I was able to find a muffler at O-Reilly auto parts near me, I had to use a hanger at the end of the muffler system to take some weight off the total system and I also made or use a support under the muffler supporting the muffler itself so not to fatigue the the collector at the...

Nytro has been put back together and its alive again. Can't wait to ride this thing, IT'S A BEAST.

Also where did you find that awesome side to side crossing taillight you install on your video?

What model Magnaflow did you use on your seld?

So it happened I pulled the motor and reinstalled it too. Take pictures of all the wiring harnesses on each side of the steering 4 point. I mine I had to buy the special motor mount removal tool (search eBay) if you are in the Flint area I could let you use mine if needed. Michigan that is, I...

I will request it like you pointed out. Thank you!

How do i find the manuals on the site now? LOL