Search results

Looking for a good set of 3 (green) 430cc injectors to fit a Yamaha Nytro. Thnx.

Have an older '06 Apex with the white face gauges but have always liked the newer black face gauge...has anyone tried swapping out the old one for the new style? (Did not come up with anything on the thread search).:dunno:

Just wondering if anyone running the full Hindle setup with a PCV/Autotune has figured out the midrange hesitation? Are you adding fuel to the midrange on the map? (Also have modded airbox). We tried adding fuel and it seemed better (was end of season) but mileage went for a shite.

Anyone know if there is an updated driveshaft for the older Apex's that won't shear after 7-8000mi (am running extroverts)? Also, the dupont sliders wore out in front of the front wheels on the mono (has mega float shock) after a short time... does sucking up front limiters or setting the...

Note: Moderator please feel free to move this post to buyer/seller feedback forum as it appears I do not have sufficient privelages to post there. Long story short, this member advertised 2 Nytro trail tanks f/s (post removed yesterday) to which I replied and seller made deal to ship/sell both...

Hi just wondering if anyone out there has a Warrior 136" and can pm or email a pic/sketch showing the mounting dimensions as we would like to put a Warrior skid in an SX chassis.... Email is philk@mts.net thanks. :sled1:

Anyone running Mobil 1 0-40W (European Car Formula) synthetic? Been using Amsoil and was wondering how this rated...

Just wondering if anyone out there could send the measurements of the mount holes from their 136" Warrior? Want to install one in another yamaha and don't want to drill more holes than required... Email is philk@mts.net if you have a pic thanks. ;)!

Has anyone run a 14" wide track (Phazer) on a Nytro...am considering long tracking and have access to one. Also, anyone know if it will take a 1 3/4" tall lug? Thanx.

I have a larger capacity rear heat exchanger for short track RX, RS, Apex,etc. listed in the classifieds if anyone is looking (helps with low snow overheating). ;)! SOLD.

Anyone ever try Shell Rotella Synthetic 0-40W oil in their Apex?

Would like a little more tunnel clearance to the track... anyone have any info. on how to lower the rear brackets (middle set of wheels has to be lowered also?) and what to look out for?

Anyone done the tunnel dump exhaust? Can you use glasspacks or a streetbike exhaust and do you have to add baffles to keep the noise down? :-o

Will do a search but was wondering if anyone has had success with fabbing/installing rx-1 under tunnel exhaust? Are you using glasspacks or streetbike mufflers? How do you keep the noise levels down...are you using baffle inserts? Thanks.

Anyone have a pic of a properly gussetted/repaired w-arm? The cracks need to be welded up....

Does anyone have a pic of a properly gussetted/repaired w-arm? Going to get mine welded up before the cracks get too serious....

Anyone have any ideas on installing a nytro xtx skid in the RX-1...will it fit?

Went to start the RX the other day and it wouldn't idle or run properly. Suspect carbs may need cleaning but also noticed at least 1 of 4 exhaust clamps loose and jumping around (exhaust gasket(s) likely shot)....will worn out exhaust gaskets cause this? Thnx.

Would like to put some Apex bars on the RX-1, does anyone have a pic or schematic of the correct wiring (parallel vs. series)? Am I going to blow any fuses?

Has anyone run Pilot skis on an Apex...can you make them fit (width and rubber bumper)?