Search results

Hartman engineering great service paired it with extrovert drivers he has but he make them to order an after the fact he didn't have a 137 but he would make the 136 an inch longer

I went 136 love it should of went 137 then you can get a ice attack 1.375 pre stud would be ultimate

what exactally is the rear limiter strap in the skid supposed to adjust on these sleds anyway is that the weight transfer ?

ok so iv fixed my idol issue rebuilt my clutch roller pinn ect.. i have full excell system, pc5 an air box mod but now its time to do some clutching never really got into clutching much but the sled is 9500 rpm an sounds like its bouncing off the rev limiter from wht iv read it shouldnt be...

well took it out today just like idle air on a car came out nothing attached to it from inside I see absolutely no reason why Yamaha couldn't sell this part it ohms out correctly but will not pull it self back in I found a set of throttle bodies but I don't see y I couldn't just swap the isc...

elka stage 5

ya i never heard of it before either i found a set of throttle bodies for 200 but im going to try an free it up tomorrow night ahah ya mother nature is a crule bitch lol think ill order the stater for my trx700xx

no one ?

finally figured out the nytro when in diagnostic mode last night there's a test for the isc idle speed control unit when on 54 in diag mode press the hand thumb warmer down and it will cycle the isc open to close 3 times an you will hear / feel it moving did it 2 times seemed weak 3rd time it...

it has nothing to do with the clutches it will idle fine then not clutches an all the Dumb #*$&@ has been done this is deeper im looking to see if anyone has done this with good results

still fighting a idle stumble / low end stumble not so crisp throttle response anyone ever do a syncro on the throttle bodies it says u should do a valve adjust first but i only got 16000 km could i just do a syncro anyone do it before with good results

i litterally dont have any money for air box mod i know its simple but its 225 cant afford it right now

hi wondering if anyone has a map i could use for a 2009 fx nytro with excell header and muffler no airbox mod ( i know i should do air box mod but can not afford into deep already an i should get auto tune but agian next year not this lol thanks

cool what air box mod instead of k&n ?

so i need a pc5 with ulmer map an air box mod an i dont need to get the auto tuner

wow ya Ur right i was going to buy a pcv an auto tune but there pretty expensive an i was told it would be fine the Yamaha fuel injection wont compensate for it ? also i remember a post on the apex where you could get into the fuel management an rich an lean yourself is that possible on the Nytro

ya thanks red an viper will do i alread had tje rollers ordered before i took it out but they wont be here untill monday :( just alittle bit longer till im sledding lol

plugs are new exhaust dounts also new with the exhaust theres litterally 40 km on this new set up

no didnt do any clutch work or programmer but i did put a full excell system on checked my roller in primary all have pretty sever play 1/8 to 1/4 movement when u grab the roller with you thumb an index finger an move it up an down or in an out

ya i was defentally thinking fuel aswell but now i domt know because i put it on the lift an whit no real load on it it would spin up to 200 km but it still seemed to have the burp like a governer at 200km aswell an the fuel in the exhaust is unburned so id say its getting fuel an when i aas...