fx nytro

I have a 2008 Nytro RTX (Anniversary edition). When I quickly let off the throttle after having it wide open, the cluster flashes Er_1 and then the sled shuts off for a second or two and then comes back to life on its own. The sled only loses power and flashes Er_1 in that one specific scenario...

I just bought a 2013 FX Nytro and was told that the rear suspension on it was a bit stiff because of a previous owner being a bigger lad and replacing the rear torsion springs with heavier models. I was hoping to buy lighter springs but wasn’t sure what to get. I know that there are 3 different...

I just recently installed an m-20 in my 2010 fx Nytro. I have only had a few short rides on it to do some basic set up. I guess my first question would be where do you have your limiter strap set? It rides good but is a bit darty and likes to pick the inner ski up on corners. Id like to get the...

I’ve got an 09 nytro that I can hit the key and it will start right up for a few seconds then quit. If I hold the key in the crank position it will stay running until I let the key return to the run position! I’ve been all through this thing and just seeing if maybe anyone can help me out. Thanks

I was wondering if anyone could help me out that has a LTX. I’m installing a 2018 LTX 137” skid in my Nytro. I’ve looked and can’t find any info on doing this, many have done the 141 or mountain set ups. I’m looking for the distance from front mounting hole to rear mounting hole. I can measure...

I finally got my gyroplane back in the air (it was indeed a head gasket), but the power just isn't where it should be and compression tests lead me to doubt the rings. Short term, I'll looking for another engine or long block for a 2008-2011 FX Nytro. I would consider a used engine with less...

Me again...that Yamaha-powered gyroplane guy. I'm having a bit of an overheating problem. My implementation is setup the same as several other gyroplanes we have that operate without issue, so I am confident of the plumbing. In the recent past, I have replaced the water pump (cracked...