137 Skid Transfer ,

[sledheadgeorge]

Has anyone tried to relocate front shock of rear skid to this location and seen any change in skid transfer?

 

[jonlafon1]

Not sure about what your suggesting. Take the plastic blocks off the back and use some heater hose over the metal bar where the plastic transfer blocks were. It will transfer

 

[jonlafon1]

 

[jonlafon1]

Now this will make the skis just float off the ground about 2-3 inches. You will have to replace the rubber heater hose every 2000 miles or so.

 

[jonlafon1]

 

[waldo1]

ran a 137 for thousands o miles - same set up - no hose - dont need it - the correct way is to use a stronger spring on front skid shock -

 

[sledheadgeorge]

Not looking for more transfer. Just asking if anyone has relocated the front shock to the location shown. And what are the results.

 

[waldo1]

O -- right - that frustrates me also when the question gets avoided... ill ask around - i know a good suspension guy ... looks like it will hit the wheels... im done with the 137 - 141 is way better unless u ride alot of huge bumps ... 137 is probably a better bump sled, but its alot heavier so its tough to doo bumps for long... the new srx with no fuel is like 605 # - 17 xtx is 555...