My planned mods are now done, or at least I have the parts
Finally got my Curves, ended up buying a set second hand but they are in good condition, and only $175 with mount kit and slightly used 9" sharper bars.
I lowered the skid to the lowest holes as well, put in the Zbroz #160 center spring and the sled rides very nicely now, absolutely no darting, best riding sled I've ever had.
Other mods;
Swapped the front Float 3s with a set of Fox QS3s. Absolutely love them, worth every penny! Bought them brand new from a guy who sold them on the Viper forum on Facebook. Paid $100 less than Country Cat wants for them on eBay and are a take off from a brand new '16 LTX. I ride them on the softest setting, #1, and work awesome!!
I finally pulled the trigger on the Hygear linkage kit and Dual Pressure kit for the rear Float. Got it installed towards the end of Easter and didn't get to put too many miles on after it, so not sure what think of it yet. On top of it I think the Dual chamber is leaking as it seems to bottom out too easily. I started with 200 bars in the Dual chamber and 120 in the main chamber. However, when I attached the pump again to the Dual chamber I couldn't get any pressure reading on the pump... I'll have to take the shock off again to check it.
According to the Hygear instructions the inner idler wheels needs to be taken off when running the linkage kit AND the Dual Pressure kit. But the wheels, or more correctly the wheel mount, can be turned around and placed outside the rails. I just need to buy a set of matching wheels
I also have the fan reverse, fuse relocator and Japan throttle from BoPs but didn't get time to put these on yet. I guess that's my summer project
You can read about the rest of the mods further up this thread
The trail conditions changed quite a bit over Easter, starting with rock hard trails due to mild temps the week before Easter and then turning cold. Last Saturday the temp went up and the trails became super soft again, so we got slushy spring snow.
