pc3 +ignition modual wont idle warm

[daboondocker]

I have an 06 apex gt I bought used and it came with a pc3 and ignition Modual ..I just installed them and the cr10ek plugs the sled starts and idles fine but when its all warmed up and I give it a series of high revs it comes back down and bareley stays running sometimes stalls.. it is still 60degrees here not sure the higher outside temp has somthing to do with it. I sent the pc3 to uhlmer last year to make sure it was programmed right and it was. Just looking for some help before I get on the snow this year. thanks

 

[slowride06er]

How many miles are on sled? Did you try returning sled back to stock to see if problem goes away?

 

[daboondocker]

I ran it stock all last year and finally decided to put the programmer and ign. Mod. on this year it ran fine previously.. it has 4800 miles on it

 

[slowride06er]

I would disconnect everything put it backto stock and see if yyou still have problem. Are you getting any codes?

 

[VMX]

sometimes these motors will skip a cam tooth happened on mine exhaust cam off 1 tooth stalled after coming to stop while ridding

 

[tomanytoyz]

It's probably because it's setup for the cold to give more fuel and you said it's 60 degrees out ? I had my pc3 in the past act up when it got moisture inside . Removed , dried , di electric grease , sealed and stuffed in a ziplock bag. No issues so far. Disconnect and see what it does with out programmer .

 

[HABS 1]

i think most maps are not changing any fuel or ign timing at idle, ign timing is only changed at wot and fuel above idel rpm, nothing is changed at 0 throttle position, let us know what u found!!!