Problems 3 Bar Map Sensor

[Mike Belanger]

I have 2017 Sidewinder and I'm trying to go with 3 bar map sensor but with my luck the Plug on my sled is different....Any suggestions?

 

[rnusr01]

Are you sure your trying to replace the correct sensor?

 

[Mike Belanger]

Most other Sidewinders both barometric and map sensor are the same but mine is not

 

[rnusr01]

odd

 

[Mike Belanger]

for sure...just don't get it...i'd post a pic but not much of a tech to figure it out lol

 

[Mototown]

Where did u buy the sensor?

 

[STAIN]

My barometric sensor and MAP sensor are not the same plug. The MAPsensor is towards the middle of the sled

 

[Mike Belanger]

Always deal with Dave ( Hurricane ) was on the phone with him all day don't make sense to him either

 

[Mototown]

I would check on line parts , check wire harness #. & sensor. Might be able to change that section of wiring

 

[actionjack]

I have 2017 Sidewinder and I'm trying to go with 3 bar map sensor but with my luck the Plug on my sled is different....Any suggestions?

Did you get this cleared up? I plan to install mine today. Maybe you received (or ordered ) the wrong one.

 

[Mike Belanger]

No have no cleared it up but made it work lol....have the same 3 bar map sensor but my plug on the sled is different, the 2 tabs on the side of your 3 bar my plug on the sled has the tabs closer to the top...not in the center like the 3 bar so I used a Dremel and shaved the tabs off...don't understand why my wire harness is different on my sled.

 

[staggs65]

No have no cleared it up but made it work lol....have the same 3 bar map sensor but my plug on the sled is different, the 2 tabs on the side of your 3 bar my plug on the sled has the tabs closer to the top...not in the center like the 3 bar so I used a Dremel and shaved the tabs off...don't understand why my wire harness is different on my sled.

Maybe an early build

 

[baggs66]

Can you install the 3bar sensor on stock sled and run with no problems? I will be adding my tunes after some breakin but would like to install this and my bov to have done now.

 

[KnappAttack]

Can you install the 3bar sensor on stock sled and run with no problems? I will be adding my tunes after some breakin but would like to install this and my bov to have done now.

No you can't, nor is there any reason to run a three bar map sensor on a stock tune. The tunes are reconfigured to run the 3 bar sensor. It only take a couple minutes to switch it out anyway. Same with the BOV takes a couple minutes to swap out.

If you're running stock then just run stock stuff. Nothing to gain switching even the BOV on a stocker. Do it all at one time.

 

[WVTurboLTX]

Can you install the 3bar sensor on stock sled and run with no problems? I will be adding my tunes after some breakin but would like to install this and my bov to have done now.

No, your ECU will not know how to properly read that sensor.