Template for drilling buckhead to accept mpi supercharger

[Sunshineb20]

Hey guys ! I recently bought a used mpi 180 supercharger kit for my nytro and was wondering if anyone had a template or even some measurements to start a pilot hole? Thanks in advance !!

 

[MrSled]

Have you looked here:

http://www.mountainperformance.com/Files/Download/msn-0900_supercharger_nytro_8-8-11-small.pdf

http://www.mountainperformance.com/Files/Download/msn-1000_supercharger_nytro_8-8-11-small.pdf

 

[Sunshineb20]

Have you looked here:

http://www.mountainperformance.com/Files/Download/msn-0900_supercharger_nytro_8-8-11-small.pdf

http://www.mountainperformance.com/Files/Download/msn-1000_supercharger_nytro_8-8-11-small.pdf

Yes I have it all printed off and it shows the location but not exact. I only wanna drill once and not have to dremel to fit

 

[MrSled]

Yes I have it all printed off and it shows the location but not exact. I only wanna drill once and not have to dremel to fit

Got it. I did this without template and I think I went a little bigger with hole saw and it worked out great. Good luck.

 

[Sunshineb20]

Got it. I did this without template and I think I went a little bigger with hole saw and it worked out great. Good luck.

Maybe that's what I'll do to !