Tether Instalation

[phazerboy73]

Hey everyone, I have a 07 phazer fx and am hooking up a tether. I did some research and found that I need a normaly closed tether. I have this and want to know what to hook it into. I found my kill switch wires and am wondering if that would be the easiest way. It looked like on past 4 strokes people have spliced into the brown wire which i have found. I am just looking for some clarification on this subject regarding tethers on the new phazer. I can get pictures if needed. Thanks a bunch

 

[phazerboy73]

Never mind I figured it out.

 

[TIMSMXZ]

were did you splice into?

 

[phazerboy73]

I basically did the same thing that was talked about in this topic.

http://www.ty4stroke.com/viewtopic.php? ... ght=tether

I found where my kill switch wire was able to connect and disconnect which is a little ways below the handlebar mount and off to the side. I spliced the all brown wire above that connection and put a male and female connector on so if needed I could hook them back together. If you need pictures I can try and get some up.

 

[checkman39]

so your saying you wired one tether wire to one side of the brown wire and the other tether wire to the other side of the brown wire right? I will be doing mine a few days.

 

[phazerboy73]

so your saying you wired one tether wire to one side of the brown wire and the other tether wire to the other side of the brown wire right? I will be doing mine a few days.

Exactly right. Then when the tether gets pulled its cuts it off basically like the kill switch. I dont see any reason as to it harming the snowmowbile but I am new to the 4 strokes.

 

[Phazed-Coug]

It should work the same as turning the key off.
Interrupt the 12 supply to the key, and it should in theory work.