tors question

[ScottyD]

had some issue with my tors, got the cable adjusted, thought i had the problem solved, now when your cruising at a steady pace, not speeding up or slowing down, not chopping the throttle, the tors will go off and flash the code and the sled will drop to idle
anyone got any ideas?
the cable is adjusted to the manual specs

 

[TBay Sledhead]

The switch could be defective.

 

[cat hunter]

Just bypass it if it gives you too much trouble!!!

 

[ssgzag15]

I thought everyone bypassed their TORS as a matter of course...

 

[grizztracks]

The throttle positioning sensor on the side of the carbs is adjustable. I've had to fine tune the TPS on a couple of the RS sleds that would continuously trip the throttle override. It requires a tamper proof torx bit to loosen the set screw. The manual gives a long drawn out procedure to set it but I just move it in small increments until it stops tripping the TORS.

 

[Bluebullet]

Mine used to do it if I was turning around some times check your cable routing on the handlebars if it's just a little out of place it can also cause it to throw the code. I ended up tie wrapping mine and havent seen it happen again.

 

[ScottyD]

Just bypass it if it gives you too much trouble!!!

how do you bypass it ?

 

[TBay Sledhead]

There are two wires going to the switch on the throttle slides, disconnect at the plugs and plug the wires coming from the harness into each other.