Turbo blanket?

[rxrider]

witch one of those can i use on my Mcx 19T turbo to Nytro with wastgate on topp?

The 19T and the GT2860 is pretty much the same size, it's always better to use a blanket that is too large than one that is too small.

Here's a link
http://www.horsepowerinabox.com/HPIAB2/category60_1.htm

 

[MRFUSION]

You ever used or seen on of these brands (horsepowerinabox) rxrider. I contacted PTP on their blankets but they have no relief for internal wastegate. They recommend the flat wrap genesis style but Im not sure about it. Thanx Shad

 

[Tarzan]

Thanks Rxrider

 

[rxrider]

No I have not, could not find the Subaru Speed shop in Australia I got mine from. I'll keep looking.

 

[rxrider]

After checking ebay and other sources all turbo blankets made for garrett gt25/gt28 looks almost the same. IMO anyone of them will fit as long as it's made for a GT25, GT28, and so on.

On the GT2860 I have no issues with the internal WG, actuator or the acuator rod. You can cut the blanket material if needed for clearance.

 

[Lester]

Cutting an X in the blanket for the wastegate works good.

 

[Tarzan]

So i can cut a hole for the wastegate rod and a X over the wastegate pin where the rod are connected?

[/img]

 

[TWIN TURBO]

I don't think the blanket I'm talking about will fit that turbo. Made for a Garrett T25/T3 Housing

 

[rxrider]

It's supposed to engulf the exhaust turbine housing.
You will have to cut a hole for WG leaver, enough for it to move around freely. Remove the actuator arm and install the blanket. Install the turbo into the sled.

 

[Tarzan]

It's supposed to engulf the exhaust turbine housing.
You will have to cut a hole for WG leaver, enough for it to move around freely. Remove the actuator arm and install the blanket. Install the turbo into the sled.

Thanks Jan