Recent content by yamaha247365

I took my thermostat out to check to see if it was working and I wrecked the gasket. Anyone have a part number for the gasket or the thermostat?

I have the heel clicker two speed kit with a black spring. Looking for a baseline setup for 09 FX 121" with full exhaust, intake, plugs, fuel map.

Thanks to Pete's post I found it. 90109-06174-00

Thank you. By chance do you have the number for the bolt in the picture? I believe it holds down the tail light and hold the side plastics to the aliminum exhaust shroud.

Well that won't help me now but I don't know that trick. Does the compound give the driver more grip?

Would the dealer stock these bolts?

So I took off my nose cone and had to drill out the phillips head screw/bolt. I need to replace them. I found the same bolt on the rear side plastics with a 10mm head. I would rather have the bolt head but I can't find where to buy them. Fastenal could not find anything close. Any suggestions?

That's what I needed. Thanks.

I bought a used Ulmer k&n intake kit. I need help installing it. I cantacted Ulmer Racing but I'm sure hes busy. Anyone have any instalation instructions? My build is at a standstill untill I get this kit installed.

My over heat light came on twice last year. While installing the header, my donuts were pretty much gone so I was leaking hot exhaust in by the engine and a mouse got in and shredded most of the insulation in the box around the flex joints. So I think my overheat problem came from that. The...

I'm cheap. Almost everything I got was used. Lots of guy take parts off and put them back to stock when they sell them. Lots of searching classifieds.

not even close. I'll have about $2000 in it when I'm done.

Bought a 09' FX Nytro in 2011 used. Rode the sled as is due to lack of funds. Now I'm a little more set and with current snow conditions and predictions I cant justify buying a new sled so I decided to do all the mods I wanted to do from day one but couldn't afford. Heres my list. Most are done...

I got one of there headers to make an under tunnel exhaust. I just wanted to know if I needed it. I will be getting an after market muffler and I have a modified intake and a power commander V on the way. Thanks for the responses. I decided that if I keep this sled long enough to save me from...

Good to know. Haven't done my clutch yet.