Recent content by boone

broken driveshaft Thanks for your input. boone

The first shaft broke at 6400mi last fall I insalled a extented 136 " track new bearings and seals and new drive shaft after 2700 mi on the new drive shaft it broke right in the middle. any ideas :o|

Re: transfer rod I can't post a pic :o|

transfer rod Ran without it for over 3000mi no problem, the back pivot...

transfer rod Yes you can run without the rod I have for over 2000mi, but the rear of the suspension can reverse and get stuck you then have to pry it lose. So I put a set of old polairs blocks in that stop it from getting stuck.

servo motor When my wires broke I took the rail out and soldered the wires, put insulator over solder rerouted wire, 6000 mi later still good. boone

New track, 8 over size boggie wheels, and 2 little wheels on the front of the rails. I know you only have 6 wheels but I added 2 more on the rail ext. for the 136 " track. Its also getting a new drive shaft and chain. My question was {with the longer track } would it be better to stay with the...

The sled has over 10,000mi on it and I am changeing the bearings to be safe. My 04 warrior had 13000 mi and the top chain case bearing went out and took the chain case with it. boone

What set up for the best miles per gal. I have 06 apex gt with 136" track and I am going to replace all the bearings in chain case, should I stay with the stock gears and stock primary spring or go with the attak. gearing and spring? thanks :4STroke:

67 yrs starting to slow down 06 Apex Gt 10,000 plus mi. :4STroke:

Over 10,000 mi stock plugs. :Rockon:

Did you burn flat spots on your belt? boone

First off thanks to mr. sled for the web site. I have had a lot of help from guys on this web site, turk, bigger hammer , tork and many others. What happened was I was trying to back up and it sliped, so I thought the belt got wet from the deep wet snow. Some time it would go in and back up and...

track clips On my 06 GT I lost most of the track clips. so I took the rest of them off, add the small wheels up front of the rail, put on over sized boggies wheels and added the bolts to the closed windows. So far looks good as far as the track go with over 1000mi with out the track clips. Now...

Had mine changed out 6000mi, 240mi later leaked again found out the pipes were cracked $600. for the pipes. Yamaha needs to go back to the 04 pipes, heaver butl last . :o|