Recent content by justin gallant

heres a few pics of my apex... to many mods and customization to list lol

I did this mod...love it .the only thing is the inside of the lights seem to fog up when I take the sled from warm garage to outside. I'm not sure if it's because the light is not sealed right!?? hmm

is this corrected by adding or taking washers out on my secondary clutch?

what is the best belt to run on my apex? i have Ulmer's clutch kit. i also noticed that i have wear on one side of my belt. What can be done to fix this problem?

I wonder if it's just a decal?and if they instruct the light ?

How did you get that tuning fork lens..?? That's the best looking projector so far..nice work!

Just did valve adjustment ,I reset the CO Value to (0) , installed Excell exhaust and CR10EK plugs on my apex. Now when i have the sled on a stand and snap it i have a delay or a stumble. once its past that it runs fine... any ideas??? to rich to lean? mabby adjust the CO?

No that's Not the case. Valves get tighter on the exhaust side on these normaly not looser.

Yes lol thanks

well im back after one season running with that same co adjustment. it started to act up on me again so i checked the valve clearance and my exhaust side was way out of wak!!

Could anyone direct me to the CO adjustment procedure on here. seen it before with pictures and instructions on how to perform the procedure but cant find it now!! its for a 2006 apex

Rokz are the way to go iv been reading!!?? Imndoing the projector change over..do I need to get h1 or h4 hid's? Can I buy a set from eBay for half the price or are they junk?

First of all very nice build. I'm going that route with mine. Just ordered the projectors..what or witch hid's do I need to get.?? Are they h1 or h4? Could you send me on the right track?? So mankind on eBay Cheers

Are they better than leds?