Recent content by macnytro

What did you use for motor mount

Not sure I am still trying to get mine installed if I get some dimensions or measurements for it

You could do bracket with 2 sets of holes or use adjustable front brackets terra alps also told me to mount mine closer to take weight off the front end. I have 2 ez ryde skids 155 and 159 and trying to install the 159 with no luck at this time

do you have a diagram from tera alps, if so can you sent it to me? it is probably further back because your drivers are bigger then the 3" pitch ones. 9 Tooth 2.25 drivers are 7.219" & 3" 7 tooth are 6.685"

Good luck I've been looking to with no results. I do have a drawing that I tried to send you but it didn't work pm me I will try that way

Any body do an ez ryde skid in nytro? Looking for any info on install or pictures i have no brackets or measurements for a 159 I do have 153 measurements. Thanks

Any body have any information on installing a ez ryde in 08 nytro i do not have the ez ryde brackets and the rear measurements i have are not lining up. I have 2 skids 153 & 159 thank any help is appreciated

I think I sent you a pm

Thanks for the looking for my buddy I had bought some for his apex years ago but he has a vector for his son now

Does anybody still make the copper exhaust gaskets for the vector in Canada if not any where else thank you

the instructions are on his web site but i do have a copy of the instructions if u want them all i need is your email

thanks athiel i just did an oil change to it last light when i put the turbo back on and hope to try it out later today not much snow left here.

glad u found your problem, i am still working on my trying to figure it out. i am putting it back together and going to run it again to see what happens

mine runs fine just blew oil out the breather