Recent content by Michael Potter

I would not heat case up might melt seal. Best way is to press in. Put a little oil on outside of seal.

Just a question. If you lubricated the seals how did you keep that oil off shaft while inserting into new bearing with blue locktite?

Add me to the list of screwed drive shafts. 4000kms and it’s done. Have to order new shaft tomorrow. I will be ordering shaft lock for break side from Barn of Parts. So that side is covered. I also noticed that on the gear case side the bearing also has some play. What are you guys doing...

Just finished riding and have 3247Kms on my belt using Dans set up and Hurricane alignment tool. All Kms running 270 tune. I think problem is fixed. May change belt as I don’t want to push my luck too far. Thanks to Dan for posting his set up and to Hurricane for creating the tool. Mike.

I’m going to run some Seafoam in the fuel for a bit.

I had the same thing last weekend. Low on fuel light was on. Sled started acting as if it was out of gas hesitation but no backfire. Gave it some more throttle hesitation went away finished the last 20 kms. Probably on fumes by the time I got to truck. Mine is a 2017 and only had this...

Hi Guys Just putting my rear skid back in and I can’t seem to find the torque value for the two bolts that hold the rear skid to the tunnel. Thanks

Hi Dave. Did you take the float plug to a machinist to remove the 4mm? Also where did you get the outside washers? Thanks Mike

Hi Dan. Thanks for all the info. Just to confirm. When you say B/O I’m assuming that’s the Dalton Black Orange spring. Lastly can I ask where you purchased the glide washers from. Thanks again.

Hey Dan Did you ever get around to installing the BOP throttle? Is so how was the install and more importantly how does it work? Thanks

Thanks for all the great ideas, I decided to go with this. I think it came out good IMG_4557 by Michael Potter posted Nov 30, 2016 at 9:50 PMIMG_4556 by Michael Potter posted Nov 30, 2016 at 9:50 PM

Hi Guys, I came across a post where someone posted the OEM clutch holder but now I can't locate the thread. Can someone give me the OEM part number for the clutch holder? Besides this holder is there another less expensive option that is safe so that I can check to make sure the torque on the...

Hi Guys, Live in Northern Ontario and was wondering where everyone is mounting license numbers. There is not a lot of room on the sled. Pictures would be great. Thanks Mike