Recent content by NorthernRider

  1. NorthernRider

    SD26 on BTX

    So I went to my dealer to price new boost sensor he wanted $400. I wanted to double check everything before I pulled the trigger on it. I pulled all sensors, cleaned all boost lines, and checked sensor routing. I also pulled the inter cooler and fleecer was correct it had water in the bottom of...
  2. NorthernRider

    SD26 on BTX

    I put it in the heated garage for a week, it still had error when it is taken out. I’m haven’t had time but I will try pulling the intercooler out too. I do 50/50 on trail off trail so I could of picked up some moisture. The trails here are awesome if I wasn’t paranoid about my code be even...
  3. NorthernRider

    SD26 on BTX

    Next question any one know where find the info to test the boost sensor and the related solenoids or a shop manual?
  4. NorthernRider

    SD26 on BTX

    Ya it’s why I built the pressure tester I was sure I had a hole or leak some where but did test several times and it held for all them. The code last season would have the engine cut out briefly. So I know what it feels like. It won’t do it this season even tho the code is permanently on the...
  5. NorthernRider

    SD26 on BTX

    Yup got that one. Changed it to be safe. I don’t ride with any one that has a winder to compare my sled to but mine feels the same as the ones I test rode on the demo day before I purchased mine.
  6. NorthernRider

    SD26 on BTX

    So I turned sled on brought up to operating temp code was present. I turned it off and put red battery lead to negative on battery with the key on and off for about 30 seconds in each key position. Restarted sled code was gone but came back on within about 1 min. I find it very strange. I have...
  7. NorthernRider

    SD26 on BTX

    Fully understand I will try it
  8. NorthernRider

    SD26 on BTX

    Pulls great, Hang on tight pulls. Had it up to 160kph yesterday very quickly with no issue even tho code was present on dash. Last season it flashed Sd26 on WOT runs and would reset when turned off sled after tightening clamps never came back apart for maybe one lake run. Last week it came on...
  9. NorthernRider

    SD26 on BTX

    Hi, was searching the forum but can’t seem to find the answer any where and I’m scratching my head. I have a 18 BTX that was randomly throwing code SD26 last season. It would reset after the ignition was turned off. I figured was a boost leak thanks to this forum so I tightened all the hose...


Back
Top