Recent content by rev them up

The one on my 2011 nytro sounds bad, have apart and spinning sounds like sand in a bottle being spun. I re greesed it 2 yrs ago and was fine at the start of the year. Has 15,000 miles. Will also be replacing the one on my winder this year.

Thanks.

Replacing the stub shaft bearing on the Nytro and Sidewinder, local spot doesn't have them, can get them from cat, assuming they are the same bearing and will fit both sleds?

Has anyone taken off the Hindle muffler and used a different muffler on the hindle pipe? Muffler is a 16inch oval, wasn't sure if it is possible to use a different muffler with the pipe.

PRECISION EFI sells filter kits. Cdn company unsure if Cdn parts.

I couldn't get them to work on my winder or nytro, great ski over 30mph, under that a complete bear to turn. Put tuners back on with snowtrackers.

I have been trying to dial these skis in since late last winter. I can't get them to where they work. Below 30mph they are an absolute bear to turn, have to crank center spring to lighten the steering, but that then throws the suspension out as I find the sled gets tippy/pogo stick like. In...

Just be aware if you are running Dalton it will act differently then a Yamaha spring at the same rate. I run a Yamaha G-W-G in my Nytro(45/136). If i put a Dalton b/b spring in(53/133) i lose some op rpm. I was told that there is a 10+lbs finale rate difference between the 2.

I have a template backer, drill one side put stud thru backer then drill second hole thru the backer, remove backer and put non template backer on. Did this for every stud, all studs fit snug in track and ligned up perfectly with backers.

No it is a 2ply stud, they were in my 2ply storm track.

N-Vader Mega Stud and backers

No bubbles are hard.

The mushrooming just seems alittle more pronounced then what I am use to. But i trust your input forsure.

I have sent photos to camso, there is mushrooming wherever there is a stud.

It is a 2ply track, looked at a piece of my old track(Storm) it had a very slight mushrooming to it but nothing like this. They are the same studs/backers from the old track.