When my sled is cold the belt doesn't want to grab the clutch till i rev it up a lot. and when it catches it wants to run away until I hit the brake. anyone have this issue? I also have an apex and its perfectly fine. Could it be to tight of belt deflection? Other sleds I have it grabs as you...
There is 12 volts on the one side of the starter solenoid and the other there isn’t. I changed out the solenoid with another I had on a different sled and it ran. No change. Does the wiring going into the solenoid cut power? The clip of 4 wires in the middle?
How many volts should the starter take to roll over the engine? I checked the volts after the starter solenoid and I'm only getting 1-2 volts at the starter when I turn the key to start. TO me there should be 12 volts there unless something not allowing this to happen.
That was my thought as well. Went to grab the multimeter and the battery was low and wouldn’t read anything. I’m gonna grab a new battery and start there thanks.
I just bought a 2011 apex xtx with only 1400kms. It seem like it needed a battery. Lower on the voltage side, and would only click when I hit the key switch. So went to switch it and it arched. So now I don’t have anything. I checked all the fuses( I think) tried a new starter relay. Still...
Guys,
I have a new belt XS805 and a New stk yamaha belt that to me don't feel right on the secondary. I have all the shims in the back to bring the secondary closed as much as possible. What am I overlooking? The belt isn't to tight and still sits level on top. thanks
Guys I have a stock nytro with a ulmer clutch kit and looking for more power. Is there a map or program out there to adjust the to advance timing like the reflash on the viper? Viper pulls away from me 200ft on. Have a Hauck fuel contoler but don’t think it will do anything without a header and...
Guys I have a stock nytro with a ulmer clutch kit and looking for more power. Is there a map or program out there to adjust the to advance timing like the reflash on the viper? Viper pulls away from me 200ft on. Have a Hauck fuel contoler but don’t think it will do anything without a header and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.