Recent content by Vector LTX GT 08

Oh I agree I am going to have to play with the suspension after it’s mounted. If you could get me the measurements that would help. I am just trying something that is different from what everyone else is doing. I like the fact it has the 151” suspension/ pivoting rear rails.

Here is how it’s looking in the front factory 136” mounting holes. Doesn’t seem to be off to much

It appears to me like the front mount hole needs to be lower, and moved backwards a little bit. Thoughts? Currently the 151 inch suspension is temporarily in the OEM 136 mono shock holes.

I am currently building my 2007 attack. I am replacing the 136” mono with a 151” 2017 (700 mile) venture suspension ( pivoting rear rails). I am building a different sled as Yamaha has never done something in between on an Apex. It’s either 144 or 162”. I am putting 8t wahl drivers into it also...

The front of the suspension isn’t contacting the cement floor as the front mount holes are in the factory 136” holes. It appears the mounting hole needs to be lowered/ moved back 1/4-1/2”.

I am currently building my 2007 attack. I am replacing the 136” mono with a 151” 2017 (700 mile) venture suspension ( pivoting rear rails). I am building a different sled as Yamaha has never done something in between on an Apex. It’s either 144 or 162”. I am putting 8t wahl drivers into it also...

This grounded block was burnt inside a little, and the minute I touched it boom headlights again

Update, sensitive grounding block...

Update, one of the grounding blocks was sensitive...

Replaced the headlight relay from my brothers 2009, didn’t fix it. Headlights are dead on it

I swapped the headlight relay with my brothers 2009 relay, didn’t fix it.

Headlights crapped out on my 2008 vector . I have no high or low beam lights, but the tail lights work. Unplugged the hid lights and put stock bulbs in, nothing.... High beam indicator is on, but no lights. Thoughts?

Headlights crapped out on my sled. I have no high or low beam lights, but the tail lights work. Unplugged the hid lights and put stock bulbs in, nothing.... High beam indicator is on, but no lights. Thoughts?

Yup I just found that out yesterday and got it put back together correctly, thanks!! Looked it up on the repair manual