Recent content by Z-Rider

Every measurement that I have been able to take says they are the same. Guess I spend some time in the garage next weekend and find out. Looks like our season is over anyway

Are the 4th wheel kits the same across the board for Yamaha sleds? I have a spare kit for my 2006 Nytro and want to put it in my 2009 Phazer MTX if so

Did you turn the stock rubber 180 degrees or leave it orientated in the stock manor?

I have the narrow 2009 MTX and would like to go wider, if you are still looking

Has anyone installed Pilot 5.7 or 6.9 skis on a 2009 Phazer MTX? I have a set on my RX1 and my 06 Nytro and have two more sets. I’d like to run them on the Phazer bit obviously dealing with the different spindles I’ve tried searching but can’t seem to find much info as to if it is possible.

Would a set of 18” center to center Floats work on an RX1 considering the stock shocks are 17.5”?

Anyone know of a reputable mechanic in Michigan to swap out a cam chain tensioner on my 2006 Nytro? I have the parts, just not enough time to do it uninterrupted. Thanks in advance Homer

Do the 2003 RX1 and 2006 Nytro share the same chassis platform? Tunnel and bulkheads

Unfortunately I do not have access to the donor sled tunnel. I’ve asked around for measurements on some of the Cat forums and I’ve receive conflicting info. I’m considering setting both skids side by side with the front of the rails even with each other and figuring out the differences in...

Do you happen to have the mounting locations/measurements for putting the T660 skid in the RX1? I have a 136” Panther 660 skid I want to mount into my 2003 RX1 this spring

Picked up a 2006 ARCTIC CAT PANTHER 660 TOURING SLIDING SKID FRAME REAR SUSPENSION and want to install it in my 2003 RX1 after this season as I’m over the broken W arm issues. I don’t have access to the donor sled but figured it may be the same mounting dimensions as other Cat 136” skids from...

Picked up a 2006 ARCTIC CAT PANTHER 660 TOURING SLIDING SKID FRAME REAR SUSPENSION and want to install it in my 2003 RX1 after this season as I’m over the broken W arm issues. I don’t have access to the donor sled but figured it may be the same mounting dimensions as other Cat 136” skids from...

Anyone know of a reputable mechanic in Michigan to swap out a cam chain tensioner on my 2006 Nytro?

Okay I have pink for the secondary. Does anyone know the stock settings for the Rage or Nytro as far as spring wrap? 3-3 or something else?

Stretching my ‘06 Nytro to a 136” with a Ripsaw II from TracksUSA Any clutching changes I should consider? Different primary or secondary springs or secondary settings? Thanks in advance