Search results

Now you can not bolt your skid plate on properly and you do not have the most crutial stiffener, the back one.

Here ya go, this guy wanted a hole in the middle, they do not not come with a hole in them.

Here's a pic

If you are looking to Beef up your 08 Nytro subframe before you bend it. Click Here. http://www.snowandmud.com/forum/f124/08 ... post146448

Has nothing but troubles with Innovative. Went through sensors like crazy. Switched to AEM, and after 2500kms still good and working great. I would go with AEM.

Contact Northwest turbos. They are getting Trailtank to build a 10.4 gallon tank for them that has the recess for the turbo in it.

He is right on the money. My MCX Nytro will build maybe 1 psi of boost if I am lucky on the jackstand. Ride it and it will build 14psi no problem.

Nice job. Turned out better than mine. You finished my vision of what mine was supposed to look like. I just could not get it to bend like that. Mine did end up breaking off but it was because of my own stupidity. Turned out great. I am wondering if a guy could buy the outer extrusions...

It will idle at 1500 for a little bit but will fall to 1250 and idles a little rough. I thought by bumping it up it may run a little smoother.

Can anyone tell me how do adjust the idle on the Nytro. I need to bump the idle up. Thanks.

The stock shocks are junk. I had ohlins on another sleds and they were great. Probably going with a M10 for the rear. As far as a waste of money, I highly doubt it.

I just put the ohlins on this summer. It remains to be seen if they are worth the money. I had floats on the front this past season and did not like them at all.

One known problem but not a recall is the front subframe is not that strong. If you hit a large bump with one ski or say an erosion ditch. You will likely bend it. The front ball joints will wear out early but that will be a warranty item. Other than that there is nothing else.

Yes it is just the stock tunnel cut up. Just used a bender to bend the outer extrusions up. Took the back piece to the tunnel off and cut it up and mounted it so it was tipped up. Where the drop brackets mount to the running boards just used some stock pieces cut up. It was not how I...

Took a few evenings but here ya go.

I also am running a Hallman Evolution RX PRO and it is definately worth the money. 185.00 shipped I think. Got it off ebay. It has a dial that you can mount on you handle bars and you can turn up the boost from there. Very nice peice.

08 Nytro with MCX kit on it. My blowoff valve does not seem to be working properly. It sounds like the blowoff valve is not opening and the turbo is surging when I let off the throttle. Is there an adjustement screw on the MCX blowoff valve? Thanks.