Search results

Stumped. I bought a 2022 with the multi tune turbo dymanics tune with the dash flash. Upgraded clutches, intake, blow off valve, fuel pressure regulator, Has all the goodies. I’m running the 285 tune. When I hit the throttle once I hit between 7000-7300 rpm it backfires shooting flames and falls...

What all is involved with installing the 2.0 belly pan protector from td? Do I have to remove the foam on the bottom of the belly pan?

hey guys so far I have my heated windsheild and a hid kit tied in to my battery and i am looking to install a heated seat that will run from the battery to a relay and then power the relay off of my headlight so it will only kick in when the sled is running.. is this to much for my battery or...

Do i need to get the mbrp header pipes for the mbrp silencer to fit or can i just get the silencer and put it on my stock header pipes on my 06 apex?

hey guys the rear of my sled feels loose when I drive it.. it slides in the corners when I let off and fishtails with lots of spin.. I have my transfer rod set to wheelie mode so that is the most transfer I can put to the back of the sled correct? I have my front shocks loose as the can go and...

does anyone use the oil gallery bolt when changing there oil? what a useless stupid spot to put that. looks like you would have to strip half the sled down to get to it?

anyone run these tracks and if so how are they. thanks for the help

I am extending my apex track from a 121'' to a 136'' . The problem I have is I want the ripsaw 2 with a 1.5 inch lug. but it only comes in a 2.86 pitch and I need a 2.52 pitch. the only tracks I see that are a 136'' 1.5 lug with a 2.52 pitch is the camoplast intense and the talon 38 which is a...

hey guy what do you guys do before storing your apex as this is my 1st 4 stroke do I do anything with the motor or just the usual stuff? thanks

I left the sled out over night and of course suspension was froze solid. so I picked up the rear and dropped it a few times and loosened the sled from the snow. I went to take off and it wouldn't go anywhere. so I picked it up again and dropped it. it moved after that but now there is a new...

Hey guys when I bought my apex it would idle at about 2000 to 1900 rpm I knew the exhaust donuts were gone so I figured this was the issue. After replacing the exhaust donuts 2 y pipes and the 2 big gaskets it is still high on idle, how can I tune the idle down a few hundred rpm as not sure how...