Search results

I have a 290 MCX kit with a damaged wiring harness connector going into the fuel and boost control module. Does anyone know where I can buy these connectors? Haven't been able to source them. Any help would be appreciated.

Dash on sled is slow to light up and shuts down when you go to crank. Jumped start solinoid and unit cranks. If I jump + voltage to solinoid signal in it will also crank. Appears to be a draw on voltage in the system but I haven't been able to find it to this point. Anyone had a similar problem...

Im in the process of repairing a Nytro engine that burnt one of the exhaust valves. The engine has what I would consider low mileage at 10,000 km's so the burnt exhaust valve was a bit of a surprise! Even more of a surprise where my results when I decided to check the valve guides on the...

I am looking for the specs for valve guide clearances for the Nytro intake and exhaust valve guides. Any one have a manual they could check for me? Thx Dan

I just wanted to say thx to Dave and family for the extra special treatment and service they provided us on our visit to there shop. It was a lot of fun being there and the service was second to none! Thx again Dave and I am really excited about my next visit already. See you very soon! Dan

Just getting ready to fire up my first boosted sled build and looking for a bit of advice. The engine is a hurricane block bored to 1100cc's 10 to 1 pistons and ported head. I want to fire it on pump gas first at around 12 lbs boost. What pulley combination should I use to get close to...

Haven't looked it this before but I am considering running my apex without the reverse gears for radar running. Can I use the reverse gear cases to accomplish this?

Well I decided to try my hand at a boosted sled and figured I'd do something a bit different than most. The build is going to be a 2006 Apex, and the goal for the sled will be to reach 400HP on e-85. The sled will be used for lake running and a few radar runs. Here is where I'm at with this...

Where is the best place to get a manual for my 2006 Apex. I would really like something on line if possible. I already have the 2006 volume 1 manual which is listed as a supplimentary manual. I am rebuilding a motor completely from the crank up and I am looking for as much detail as possible...

I hope I'm posting this in the proper area for starters. I am working on my first boosted sled and have a couple of issues I'm looking for input on. I am building a stage 3 supercharged Apex and plan to run a set of excell headers. (Are there any other designs worth looking into?) My problem is...

Been looking for a kit for my Apex. Does Anyone know of someone building these still? Dan J.

Anyone know the angles of this helix???