Search results

How does the weight of the 2 machines compare? Sounds like the winder is heavier but more balanced?

How long do the copper donuts last? I replaced stock donuts with copper donuts several thousand miles ago.

Thanks for the suggestions. The bottom skid plate is intact. I'll have to check the temp of the clutches. I don't think snow is causing this as it's happened immediately at the start of day before getting into any snow.

Posting for a friend. 2010 nytro xtx, 6500 Kms. Recently he’s noticed what can only be described as belt slippage. It seems to happen regularly in deep snow, especially while trying to start, but on occasion it happens on the trail. Any suggestions as to why this may be happening? It’s getting...

every few hundred miles my sled 2012 nytro xtx decides to drop a cylinder when cold. Today after stopping for 1/2hr I lost a cylinder and it took about 10 mins to get it back. I’ve had this problem at least 4-5 times before. Changed out spark plugs or a coil and it seems to fix the problem at...

2015 viper xtx .... while riding the track position looks like a drag sled... it appears to sit very low yet it doesn’t seem to be bottomed out. I weigh about 220. What can be done to fix this? Thanks

Thanks Grizz, I’ll dig into it.

Is it a difficult job to repack/replace?

Not there at idle. It’s intermittent while riding slow. Very weird.

Don’t think it’s the brake pads. Really sounds like it’s coming from the primary clutch.

not sure how to describe this other than a metal scratching sound coming from the clutch side. This just started happening at lower speeds. Very noticeable sound. Not sure what would cause this? Visually I cannot see anything rubbing... Any ideas?

I've been looking at the sidewinder but my dealer wants 19k + taxes for the BTX. My dad has the viper XTX and it handles great but the fit and finish is far below the nytros. I was thinking about trying the doo 850 but then I'm back to a 2 stroke which doesn't excite me....

I've had my nytro xtx since 2012. It's getting older and i feel like its time for something new but i don't know even what to look at. There are so many things i like about the Nytro. Anyone in the same boat looking to upgrade? If so, what are you looking at? I'm in the market for a crossover...

How do you remove just one wheel assembly?

trying to get the front track shock out to have it rebuilt. Took the skid out, got the top bolt off the shock, removing the bottom bolt and it hits the boggie wheel not allowing the bolt to come out. Do you have to take the whole shaft out, remove the allan key set screw, remove the boggie wheel...

Can you get the shock out without dropping the skid?

I was out riding this past weekend (-25C) when I noticed that I had very little traction. Had a look at the track and the front track shock was stuck in a compressed position (limiter straps completely loose). We put the sled on its side but could not pop it out of its position. Still 50 miles...

I have nearly the same set up, 6” light bar, switch wired directly to the battery. This changed night Riding for me... there is no comparison between this and stock. I get lots of compliments on the Light bar. One other bonus is that you can switch it on while the sleds not running and light up...

Bolts seem to be tight. Have around 7500 miles on it. Problem is there is only 1/4” gap left until the shocks hit the a arms. This distance is slowly decreasing!

Hi guys, years ago reading about all the sub frame issues, I went ahead and proactively reinforced my subframe (grizz gusset). Recently my shocks have been getting closer and closer to the rear upper a arms - both sides are identical. The bolts are tight and there is no slop in the a arms. My...