Search results

Ever Figure out this issue? A buddy is having the same issue. Will the oil light come on if the level is over filled? or Just under-filled?

Buddy has a RX1 with the same issue. The Fuel gauge Level Bars flash. Ever figure out the issue?

So is it normal for a phazer to Flash OP LO at startup for a second and then go off and stay off?

The only person Id advise to ride a 08 nytro is my worst enemy. They are by leaps and bounds the absolute worst handling sled I have ever rode. The one I had was mint with dual carbides and the rubber mount reversed like people advise and fox shocks setup by an actual shop. I cringed at every...

I have the throttle cable set all the way loose and still no change in the 20 TPS reading or idle. Im going to pop the gas tank off again and mess with the idle screw thing on the throttle bodies. Could the sled be set up for different elevation?? causing the high idle?? The clutch...

looked at it today and thaT little screw is really hard to get at with gas tank on. ugh Does that little screw adjust the idle for sure? I looked at it and the way it swings downward when throttle is pulled almost seems like it would adjust Wide open throttle. It swings forward....its not...

I am interested. How much do you want for them shipped?

and is it possible to adjust that screw without removing all the body plastics and gas tank again?

Adjusting that screw out ward will lower the TPS reading in diagnostic mode?

But doesn't the fact that my 20 TPS reading in diagnostic mode at throttle fully closed indicate there is a problem with the TPS? Considering it should be at 16.

Anyone have a decent stock pair of front shocks for a 2008 0r 2009 Nytro they are looking to sell? 17.5 eye to eye measure on them Have paypal I cant post in the classified section and not having much luck finding a pair anywhere else.

Anyone have a pair of stock shocks for the 08 or 09 Nytro they want to sell? 17.5 eye to eye measure I think.

Im pulling it apart tomorrow. Hope shock just needs a rebuild and my other linkage and spring is fine.

started and rode the sled today. sucks with the high idle but still is very ride able. Im going to mess with the TPS sensor angle once I get the correct star tools. Shortly into my ride I realized my front shocks are completely shot/sacked. They sit all the way compressed and and...

What could have caused my sled to show the 20 number at closed? if its suppose to be at 16 with the throttle closed, what could have moved to make the number jump to 20? On the TPS sensor itsself I see a white line drawn from the throttle bodies across onto the sensor. I assume this is from...

Thank you for the info. Looks like I need to remove the throttle bodies from the motor to access the TPS sensor. Sorta tight up near the metal frame of the sled. Also looks like the two screws that hold it on are special star tool.....which I dont have. Ugh

How can I get that TPS number back into the 15-18 range? I updated my profile location.

The OLD ISC unit was just stuck all the way out fully extended and I tested it when removed and would not move in or out. The new ISC unit did move both ways when I tested it. Anyone know why the ISC should NOT be removed? Too late now since I did remove it but wondering what the reason...

Been trying to figure this HIGH idle issue my sled has for about a week now. 08 MTX 1.) The ISC(Idle Speed Controller) on mine was bad(stuck all way out) so I replaced it with a confirmed working one. No change in idle which I find very strange considering my old one was bad. 2.)...

tore sled down. The ISC is very easily accessible if you remove the Gas tank. Just in case anyone else needs to replace theirs.